1. Attachments are working again! Check out this thread for more details and to report any other bugs.

04 won't start - red car on MFD

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Daox, Apr 28, 2010.

Page 1 of 2
  1. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    My wife had some problems yesterday with the Prius. She was driving home and the cruise stopped working. I think at that point the VSC and yellow triangle showed up on the dash (possibly more). She stopped at a store on the way home and the car wouldn't start up again when she got back out. Now, the whole dash lights up with the warning lights and on the MFD we get the "problem" and red car with exclamation point through it. The car boots up, but it won't let you shift to drive or reverse.

    At this point I did some quick digging here and went to check the car out. I checked:
    no codes - checked with SG
    12V battery (even brought one along to jump it)
    fuses - checked them all, none blown
    inverter pump is going when turned on (its right in front of the fuse panel in the engine bay, right?)
    SG shows HV pack is at 55% SOC


    So, I had it towed home, and I'm looking for more ideas.
     
    #1 Daox, Apr 28, 2010
  2. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    Odometer reading?

    Is the 12V battery original equipment?

    If the hybrid vehicle icon appears in the MFD, then the hybrid vehicle ECU has logged a DTC. If the VSC light is on, then the skid control ECU will also have logged a DTC. Scan Gauge can only be counted on to log DTC produced by the engine ECU, so it is close to worthless in helping you to figure out what is wrong here.

    Measure voltage across the 12V battery when IG-OFF. Pls let us know what you find.

    Then, if the car can be made READY, measure voltage across the battery again and see if the voltage is ~13.8VDC. If much lower, the inverter has a problem.

    Let the car cool down, and see if it will start then. If not, you'll probably have to tow the car to your local Toyota dealer for troubleshooting and repair.
     
    #2 Patrick Wong, Apr 28, 2010
  3. firepa63

    firepa63 Former Prius Owner

    Joined:
    Jul 23, 2005
    1,761
    208
    0
    Vehicle:
    Other Hybrid
    Model:
    N/A
    You didn't run out of gas did you?
     
    #3 firepa63, Apr 28, 2010
  4. Lamboalex

    Lamboalex Hyper-Miler in training

    Joined:
    Jan 31, 2010
    37
    4
    0
    Location:
    Mooresville,NC
    Vehicle:
    2007 Prius
    Model:
    N/A
    iknow that no gas causes a red car picture on the top of the MFD.
     
    #4 Lamboalex, Apr 28, 2010
  5. vertex

    vertex Active Member

    Joined:
    Mar 27, 2009
    670
    143
    0
    Location:
    new york
    Vehicle:
    2018 Prius Prime
    Model:
    Prime Plus
    Disconnect the 12 v battery for a few minutes to clear the codes. If you have the original battery, it is probably dead. Reconnect the battery, and jump start it, you should be OK until you turn it off again. Run the 12 v battery diagnostic.
     
    #5 vertex, Apr 28, 2010
  6. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A

    55K on the odometer

    Not sure if the 12V is original or not as I just got the car last year. IGN off has the 12V @ 12.3ish so it is low. With the car on it drops to 12.0 and high 11s depending on the time you leave it on. The dc to dc does not kick in to charge it up when the car is on. Like I said, I brought another battery along and connected it with jumper cables. It made no difference.

    The car was cool when I looked at it.
     
    #6 Daox, Apr 29, 2010
  7. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    No, it has gas, almost a full tank. I wish it were that easy. :)

    Aren't you at least able to move in EV mode without gas though?
     
    #7 Daox, Apr 29, 2010
  8. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    When you say the car is "on", do you mean that it is READY? You need to distinguish between IG-ON, where all instrument panel warning lights are on but the car cannot be driven, and READY where the car can be driven and warning lights are off.

    If the car is READY and voltage across the 12V battery does not increase to 13.8V, then the DC/DC converter within the inverter is bad. Are you up for installing a salvage inverter yourself?

    If the car is IG-ON (but not READY) then the DC/DC converter will not be working.

    If the car is READY then you may be able to move the car in EV mode.
     
    #8 Patrick Wong, Apr 29, 2010
  9. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    I am not able to move the car at all, so I guess I'm not able to get into READY.
     
    #9 Daox, Apr 29, 2010
  10. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    The READY light in the instrument panel would appear, if the car managed to reach that state.

    Anyway, without any DTC to give you a clue, it sounds like you'll need to have your local dealer's service dept tech take a look.
     
    #10 Patrick Wong, Apr 29, 2010
  11. paprius4030

    paprius4030 My first Prius

    Joined:
    Aug 12, 2004
    2,077
    295
    0
    Location:
    Ormond Beach,Fl.
    Vehicle:
    2012 Prius
    Model:
    Two
    Hey if the car won't go into ready, could it be a bad brake switch? The car doesn't think you have your foot on the brake, right?
     
    #11 paprius4030, Apr 29, 2010
  12. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    I thought of that too, but I'd imagine I wouldn't get the "problem" and red car on the MFD.
     
    #12 Daox, Apr 29, 2010
  13. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    I assume that your car is still covered by the hybrid system warranty. There's a good chance that your problem is a warranted failure.
     
    #13 Patrick Wong, Apr 29, 2010
  14. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    I took vertex's advise and disconnected the 12v. I booted the car back up to find the dash lights still on (minus the yellow triangle), and mfd warnings gone, but the engine didn't start and I was unable to put it in drive or reverse (not in ready mode). I then cycled it off and back on and the engine did kick on this time. I took it for a short drive and the lights on the dash all turned off. I got it back in the driveway and turned it off and then back on again. This time it was like the first after reconnecting the battery. I got all the dash lights on (minus the yellow triangle) and no mfd warnings. Again I couldn't get it into drive or reverse.

    So, it looks like I'll at least be able to drive to the dealer, but if anyone has any other ideas, I'm all ears. Think maybe the inverter coolant pump is running but the impeller is shot or something like that? I'd think I would have got a warning while I was driving then. But, all the lights stayed off until I powered it down and back up.
     
    #14 Daox, Apr 29, 2010
  15. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    If the inverter coolant pump was the problem, you would be able to drive the car while the inverter is cold.

    I wonder if part of the problem is that your brake light switch is intermittent? Try pressing the brake pedal very hard as you are trying to start the car.
     
    #15 Patrick Wong, Apr 29, 2010
  16. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    Believe it or not that actually worked. I had to mash the brake pedal quite a bit harder than normal, but it started consistently a few times. So, the car is usable and I took it the other day to pickup some stuff. We'll see how it works and if it kicks back another code...
     
    #16 Daox, May 2, 2010
  17. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    That's great. However an intermittent brake light switch shouldn't cause the hybrid vehicle warning icon to appear in the MFD. Your car probably has a second problem waiting to be discovered.
     
    #17 Patrick Wong, May 2, 2010
  18. paprius4030

    paprius4030 My first Prius

    Joined:
    Aug 12, 2004
    2,077
    295
    0
    Location:
    Ormond Beach,Fl.
    Vehicle:
    2012 Prius
    Model:
    Two
    Wasn't there some program years ago that replaced the brake light switch for free?
     
    #18 paprius4030, May 2, 2010
  19. Daox

    Daox Member

    Joined:
    May 19, 2009
    196
    58
    0
    Location:
    US, Wisconsin
    Vehicle:
    2004 Prius
    Model:
    N/A
    I agree. However, is the code stored so I could bring it into the dealer and have it read? Or, did disconnecting the 12v wipe the code out completely so I just have to wait until it happens again?
     
    #19 Daox, May 2, 2010
  20. andyprius

    andyprius Senior Member

    Joined:
    Feb 21, 2005
    2,212
    188
    0
    Location:
    Sacramento, California.
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    Try: Put in D, keep emergency brake ON, step on foot brake HARD, Step on accel pedal full to charge, believe it or not the car will not move. Charge HV to mostly green or totally green. Then do self diagnostic check for 12 Voly battery. At that point it should read about 13 to 13.9 volts. Check voltage separately with a multi-meter.. At this point, do not shut car off, let intermittant charge process work by itself for at least 1/2 hour. Or go for a ride. Then decide if you need a new 12 V Battery. Run no accesories, shut down all interior lights. Remember that OEM 12V is puny. Too puny.
     
    #20 andyprius, May 2, 2010
(You must log in or sign up to post here.)
Page 1 of 2