1. Attachments are working again! Check out this thread for more details and to report any other bugs.

A screw fell down the vent when installing pro clip

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Sethp, Jul 25, 2014.

  1. Sethp

    Sethp New Member

    Joined:
    Jun 12, 2014
    16
    2
    0
    Location:
    Sweden
    Vehicle:
    2007 Prius
    Model:
    N/A


    This youtube clip demonstrates the iphone holder I installed in our Prius. the holder for the iPhone reqired 4 small screws, one of them fell down the vent (see pic) is this something to worry about? I haven't heard any noise or anything. Going to bring it up with Toyota during our next service. Usually when similar things happen i can take a computer and shake it about and the screw falls out but since i'm not the hulk...






    Prius dash.jpg
     
    #1 Sethp, Jul 25, 2014
  2. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    If you want, you can pull the vent out to retrieve the screw.

    This requires that you start by pulling the vent out on the far left, near the driver's door. Then remove the plastic panels above and below the steering column. Finally, you can pull out the vent to the left of the MFD and find the loose screw.

    To pull the vents out, you exert horizontal pulling force by placing your hands at the top and bottom of the vent housing.
     
    #2 Patrick Wong, Jul 25, 2014
  3. Sethp

    Sethp New Member

    Joined:
    Jun 12, 2014
    16
    2
    0
    Location:
    Sweden
    Vehicle:
    2007 Prius
    Model:
    N/A
    I don't think I want to try that i've got butter fingers
     
    #3 Sethp, Jul 25, 2014
(You must log in or sign up to post here.)