1. Attachments are working again! Check out this thread for more details and to report any other bugs.

how can I remove the back seat on a 2008 prius?

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by benk33, Jul 1, 2015.

  1. benk33

    benk33 Junior Member

    Joined:
    Jun 11, 2015
    24
    2
    0
    Location:
    Austin, TX
    Vehicle:
    2008 Prius
    Model:
    N/A
    I am needing to replace the seat belt on my 2008 Prius and I read that the first step is to remove the back seat cushion. How can I do that? Someone mentioned to pull up on the seat cushion but I am not sure how to do that? When I put my fingers under the seat cushion (the front edge of the one you sit on) I don't feel anything and I worry that I may be forcing something if I pull.

    Thanks for your help in advance!
     
    #1 benk33, Jul 1, 2015
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,470
    8,383
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    The back seat cushions are held in by bolts, the bottom seat cushion, you just lift up from the "middle" of the seat. Pull hard.
     
    #2 JC91006, Jul 1, 2015
  3. hchu1

    hchu1 Active Member

    Joined:
    Sep 28, 2006
    316
    127
    0
    Location:
    Houston, Tx.
    Vehicle:
    2014 Prius v wagon
    Model:
    Two
    Pull up from the middle of each outboard seat, you should be able to then lift up the front and pull forward the lower seat cushion. You'll then have access to the seat belt components.
     
    #3 hchu1, Jul 1, 2015
    Last edited: Jul 1, 2015
  4. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,470
    8,383
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    the bottom seat cushion only attaches from the very middle of the entire seat. Pulling up from the middle of each seat gets you nothing.
     
    #4 JC91006, Jul 1, 2015
  5. hchu1

    hchu1 Active Member

    Joined:
    Sep 28, 2006
    316
    127
    0
    Location:
    Houston, Tx.
    Vehicle:
    2014 Prius v wagon
    Model:
    Two
    I just checked, there are two latch point in the forward middle of the two outboard seats. I have corrected my original reply, the rest of instructions stands.
     
    #5 hchu1, Jul 1, 2015
  6. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,470
    8,383
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    follow the above instructions.....since he checked
     
    #6 JC91006, Jul 1, 2015
  7. Beachbummm

    Beachbummm Senior Member

    Joined:
    Sep 12, 2013
    1,160
    392
    0
    Location:
    Florida
    Vehicle:
    2008 Prius
    Model:
    Five
    lower half of the seat lifts out no tools needed than the rear folding half comes out by removing the bolts on the back of the seats, unhook the seat belts at the top of the seat
     
    #7 Beachbummm, Jul 1, 2015
  8. gptx

    gptx Junior Member

    Joined:
    Nov 26, 2008
    1
    0
    0
    Location:
    Grand Prairie, Texas
    Vehicle:
    2006 Prius
    Also you've got to give the cushion a really good strong tug to get it to let loose.
     
    #8 gptx, Sep 19, 2018
  9. Amadeo

    Amadeo New Member

    Joined:
    Dec 30, 2018
    2
    0
    0
    Location:
    Cabo Rojo. Puerto Rico
    Vehicle:
    2012 Prius c
    Model:
    N/A
    On the rear side panels you will find some plastic clips. You have to remove them before removing the plastic covers. There are 3 covers, one on eahc side and a middle one. After all plastic side covers are out, from the side of the rear seat snap it firmly upward. This should be done on both sides. Lift the front part of the seat and take out the seat belts. Remove the back seat on either side.
     
    #9 Amadeo, Dec 30, 2018
(You must log in or sign up to post here.)