1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Badge replacements or just demensions?

Discussion in 'Gen 3 Prius Accessories and Modifications' started by JarrettOriginal, May 26, 2016.

  1. JarrettOriginal

    JarrettOriginal Member

    Joined:
    May 4, 2015
    116
    81
    0
    Location:
    North Hollywood
    Vehicle:
    2010 Prius
    Model:
    IV
    I have learned that the center toyota badge is just stuck on with adhesive.

    Do we have the dimensions of the other badges, and specifically the holes they leave?
    Or know of a company that makes replacements?

    I think I'd like to 3D print out something fun, maybe Jedi or Nerd... something personal.

    Yes, everyone knows it's a Prius, but I'm just not crazy about logos.

    Seems like an easy and fun customization.
     
    #1 JarrettOriginal, May 26, 2016
    scrappy and Dylan Doxey like this.
  2. Kenny94945

    Kenny94945 Active Member

    Joined:
    Mar 24, 2016
    771
    394
    0
    Location:
    Sausalito
    Vehicle:
    2016 Prius v wagon
    Model:
    Four
    I may be wrong, yet I recall reading the front center Toyota emblem is attached with clip/ pins that are molded into the emblem. The blueish back ground is just an insert.

    The rear center Toyota emblem is applied with adhesive and has to pins used for alignment only not securing the emblem. These pins may break as you try to remove that emblem.

    UTube or like I am sure has videos on these removals.

    Good luck with your mod.
     
    #2 Kenny94945, May 26, 2016
    Dylan Doxey likes this.
  3. andino

    andino Senior Member

    Joined:
    Jul 15, 2009
    746
    550
    0
    Location:
    San Jose, CA
    Vehicle:
    2010 Prius
    Model:
    III
    I think the center rear one is also clipped on. The flanking toyota and HSD ones are stuck on along with the ones on the fenders. I wrapped my inserts when I first got the car and don't remember having to add tape to the rear one.
     
    #3 andino, May 26, 2016
    Burna J likes this.
  4. scrappy

    scrappy Active Member

    Joined:
    Mar 24, 2015
    125
    307
    0
    Location:
    Orange County, CA
    Vehicle:
    2014 Prius Plug-in
    Model:
    Plug-in Base
    The front and rear center badges are easy to remove and there shouldn't be any adhesive as they simply snap into place. Make sure to post pics of your 3D printed badges.

    This guy has videos showing one way to remove the badges:
     
    #4 scrappy, May 26, 2016
    Dylan Doxey likes this.
(You must log in or sign up to post here.)