1. Attachments are working again! Check out this thread for more details and to report any other bugs.

2003 Post-purchase advice (ECU replacement)

Discussion in 'Generation 1 Prius Discussion' started by dani0100, Dec 21, 2009.

  1. dani0100

    dani0100 New Member

    Joined:
    Dec 13, 2009
    5
    0
    0
    Location:
    Boston, MA
    Vehicle:
    2003 Prius
    Model:
    N/A
    Hi everyone -- this is my first post, so I hope it's not a dumb one! I've been reading the forums here for quite some time and am grateful for all of the information that is available.

    So, on to the problem...

    I just purchased a 2003 Prius with 86k miles on it. I am in Massachusetts, where all used vehicles must be inspected within 7 days of purchase. At such inspection, the Prius in question wouldn't communicate with the computer used by the inspection station. Thereafter, the check engine light came on, and the vehicle wouldn't start. After a few minutes of waiting and a couple of retries, the car did start up but would still not communicate with the computer.

    The car was taken into a local Totyota dealer where they advised that a new ECU would be required to fix the problem. They also said that other than the ECU, the car was fine. Of course, the used dealer we bought the car from wants to order a used part and have his mechanic install it, rather than having to pay the Toyota dealership for repair of a new unit. I gather from what I've read here that the installation of an ECU can be complicated and I'm wondering if I even want to get into a potential hornet's nest of problems if a non-prius specialist tries to install this component. As you'd expect, the place we bought the car from is claiming that it's a simple plug-n-play fix and would take fifteen minutes.

    Under the law in Massachusetts, the failure to pass inspection means I could just return the car for a full refund. I'm wondering if I should just do that, since the dealer we bought from won't pay for a Toyota dealer to fix the problem.

    My questions are:

    (1) What are the risks of having an average joe mechanic try and install an ECU on a Prius? Could they cause damage that will not show up until later, when I no longer have the right to return the car?

    (2) Is there any special equipment that the average joe mechanic is not going to have, that would be required for this installation? I see that there is a "Toyota laptop" computer that is mentioned in some threads here -- is that something that only Toyota dealer mechanics have?

    (3) Given the information above, and knowing that I'm not really inclined to do a lot of self-repair on this vehicle, would you suggest returning the car or going ahead with having it fixed by a non Toyota dealership mechanic?

    Thank you very much for any advice!
    [FONT=&quot][/FONT]
     
  2. DonDNH

    DonDNH Senior Member

    Joined:
    Feb 3, 2004
    1,711
    654
    0
    Location:
    Nashua, NH
    Vehicle:
    2016 Prius
    Model:
    Four Touring
    Here's a brief article about the ECU. TOYOTA PRIUS DIAGNOSTICS

    Replacing it doesn't sound that complicated and if memory serves, in MA the selling dealer has the final say on who does repairs necessary to pass the inspection. I'd let him go ahead and fix it for you.
     
    2 people like this.
  3. bwilson4web

    bwilson4web BMW i3 and Model 3

    Joined:
    Nov 25, 2005
    27,373
    15,513
    0
    Location:
    Huntsville AL
    Vehicle:
    2018 Tesla Model 3
    Model:
    Prime Plus
    If the seller will do the repair and the price is the same, I'd say let him do it.

    BTW, welcome to the Prius community!

    Since you bought a used 2003 Prius, I would recommend:

    • transaxle oil change - including saving a sample for potential analysis; wiping pan clean (requires new gasket); and using either Type T-IV, the original or Type WS, the newer, lighter grade and lower resistance oil.
    • throttle plate cleaning - also air filter inspection and possible cleaning.
    • 12 VDC battery testing - just a sanity check at many auto parts stores.
    • have HC capture device linkages checked and lubricated with high temperature grease. Needs someone with a lift to raise car and check linkages.
    • have alignment checked and tire depths measured, save the report. Depending upon tires, may want a 4-wheel alignment to save the tires.
    • cabin A/C filter testing and possible clean or replace.
    • lower radiator block - I use a split 'water noodle' but there are many options. Improves winter driving performance significantly.
    • start recording mileage: MyHybridCar.com, www.fueleconomy.gov, fuelly.com, ... all good.
    • (optional) block heater - about $50, it can save fuel in the winter.
    • (optional) ask how to get good mileage (should be done AFTER vehicle is tweaked)
    Bob Wilson
     
    1 person likes this.
  4. dani0100

    dani0100 New Member

    Joined:
    Dec 13, 2009
    5
    0
    0
    Location:
    Boston, MA
    Vehicle:
    2003 Prius
    Model:
    N/A
    Brian and Don: thank you so much for your very helpful advice, and for responding so quickly! I truly appreciate it.

    It sounds like I should probably be OK with having a used ECU put in the vehicle by a non-Toyota dealer, so I'm going to give it a shot.

    Brian, the list of maintenance suggestions was wonderful. I am going to look into having these tasks done. This makes me wonder if there are any other Boston-area folks who would recommend a service shop that is good with Prius vehicles. I suspect if I walked into a Toyota dealer with the list of these maintenance tasks, I would get a very hefty bill, so having a recommended non-dealer would be very valuable.

    Thanks again, everyone!
     
  5. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,472
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    Prius has multiple ECUs. If the OBD-II port is not functioning, then it is most likely that the engine ECU is at fault. It is not difficult to replace the engine ECU.

    However, I'm wondering why the communications fault occurred. This is not a common problem reported by other owners. Usually a comm fault can be attributed to a damaged wiring harness. Are you aware of any accident or flood damage sustained by the car in the past?

    In the event that another ECU is causing the fault (for example, hybrid vehicle, traction battery, immobilizer) then an independent mechanic not trained on Prius will be in deep water.

    I think you would be better off returning the car for a refund. Good luck with your decision.
     
    1 person likes this.
  6. dani0100

    dani0100 New Member

    Joined:
    Dec 13, 2009
    5
    0
    0
    Location:
    Boston, MA
    Vehicle:
    2003 Prius
    Model:
    N/A
    Patrick, many thanks for your advice. I had been assuming that it was the engine ECU that the Toyota dealership was recommending be replaced, but I was unable to confirm that today before I got cut off at 4:30 and they apparently turned the phones off for the day. The mechanic I spoke to vaguely thought it was the HV ECU, but he didn't know for sure and had to transfer me off to someone, which is when I got disconnected. Certainly that will be my first phone call in the morning.

    Regarding possible flooding or accident, there was certainly no evidence of such events in the Carfax or when I took the vehicle in to a local mechanic for a pre-purchase inspection. The only thing that might be worth mentioning is that the seller told me that when a previous potential buyer took it in for a pre-purchase inspection, the 12 VDC battery was apparently near dead, so the seller replaced it with a new battery. I know I've read in these forums that replacing the battery in the G1 Prius can be tricky if not done properly, so I wonder if that might have lead to the problem I'm seeing now.

    At this point, I think that if the HV ECU is what needs replacing, I might just return the vehicle. If it's the engine ECU, then I'm willing to let the seller replace it and see if it solves the problem.
     
  7. dani0100

    dani0100 New Member

    Joined:
    Dec 13, 2009
    5
    0
    0
    Location:
    Boston, MA
    Vehicle:
    2003 Prius
    Model:
    N/A
    An update and a question.

    A replacement engine ECU was installed. I was told by the seller that they took the car to an inspection station and it still wasn't communicating with the computer, but that it needed to be driven 150 miles for the ECU to reset and for communication to begin working. Does this sound accurate? Because if I didn't know better, I'd say it's a stall tactic to get pass the lemon law return date. I guess I'll try to drive it 150 miles as quickly as possible, but I was interested to hear from the experts here on this issue.

    Thanks!
     
  8. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,472
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    I am aware that after 12V power is restored, it is necessary to drive some distance (usually 50-100 miles) before the engine ECU will indicate that the car is ready for emissions testing. The engine ECU also needs some operating time to adapt to the engine and provide correct air/fuel mixture under a variety of operating conditions. Perhaps this is what the seller means.

    The point of this is to prevent an owner of a vehicle with defective smog equipment from disconnecting the 12V power to clear logged trouble codes, then reconnecting power and immediately having the car tested.

    So, it would be good to take the car for a long Christmas Eve drive, so that you can log the miles and then have the car re-inspected. Good luck.
     
  9. dani0100

    dani0100 New Member

    Joined:
    Dec 13, 2009
    5
    0
    0
    Location:
    Boston, MA
    Vehicle:
    2003 Prius
    Model:
    N/A
    Very helpful, as always. Thanks you so much, Patrick! I'll try to find a nice place to see in New England around Christmas time!