1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Higher weight oil in Hot climates?

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by ramdisk01, Jun 7, 2011.

  1. ramdisk01

    ramdisk01 Junior Member

    Joined:
    Apr 16, 2011
    18
    4
    1
    Location:
    Merritt Island, FL
    Vehicle:
    2010 Prius
    Model:
    IV
    A few years ago we used heavier oils in warm climates, eg. SAE 40, and lighter oils in cold climates SAE 30. As time went on multiviscosity bcame available and put these thoughts in the backround.

    Now, with multiviscosity sythetics, Is the much praised 0-20 sae, the best for all climates...(albeit it is canonized by the Toyota Motor Company.)?

    In my central florida climate, I ran my previous car with Sythetic M1 15/50 over 200K miles with excellent results. I would appreciate any thougts.:rolleyes:
     
    #1 ramdisk01, Jun 7, 2011
  2. Launch Vehicle

    Launch Vehicle Junior Member

    Joined:
    Sep 11, 2010
    82
    6
    0
    Location:
    Missouri
    Vehicle:
    2010 Prius
    Model:
    III
    Lots of start-ups require water-like viscosity. But you raise an excellent point - why not at least kick the first number up to say, five - in areas prone to being hot year round?
     
    #2 Launch Vehicle, Jun 7, 2011
  3. situationalawareness

    situationalawareness Member

    Joined:
    May 3, 2011
    83
    43
    0
    Location:
    San Tan Valley, AZ
    Vehicle:
    2013 Prius
    Model:
    Persona
    Thankfully, with synthetic the viscosity has allowed it to stay intact and useful at much higher temperatures.
    I've used 0w20 in my 2008 Prius in 115 degree temps continuously without any problems, at all. Of course, I use Amsoil synthetic oil & filters. I have a 2011 right now that is 1 day brand new, so I can't speak for Gen 3 oil changes :)
    I'm in Phoenix, AZ.
     
    #3 situationalawareness, Jul 9, 2011
  4. Teakwood

    Teakwood Member

    Joined:
    Jun 23, 2010
    491
    73
    0
    Location:
    New Mexico
    Vehicle:
    2010 Prius
    Model:
    II
    For crying out loud, we are talking about synthetic oil here, not the same as paraffin based stuff we used years ago.
    Leave well enough alone.
     
    #4 Teakwood, Jul 9, 2011
  5. xs650

    xs650 Senior Member

    Joined:
    Jul 2, 2010
    4,539
    1,433
    9
    Location:
    Northern California
    Vehicle:
    2010 Prius
    Model:
    II
    There is no reason to up the 0W in hot areas. 0w gives you a bit better fuel economy when the engine is till warming up to full operating temperature than 5W does with no drawbacks in a synthetic oil.

    If you wanted to muck with oil viscosity because of high temperatures, going from a 20 to a 30 would make more sense, but so far I'm not aware of any reason to do it on a Prius
     
    #5 xs650, Jul 9, 2011
    jcaprani likes this.
  6. ETP

    ETP 2021 Prime(Limit),24 Venza Limit,B52-D,G,F,H

    Joined:
    Apr 12, 2009
    2,802
    1,170
    0
    Location:
    Auburdale FL
    Vehicle:
    2021 Prius Prime
    Model:
    Limited

    I use 0w30 in my 2009. However since the dealer has to pay for the oil in my 2011 0w20 is good enough. 0w30 is my preferred oil!
     
    #6 ETP, Jul 10, 2011
  7. adamace1

    adamace1 Senior Member

    Joined:
    Jun 22, 2009
    1,403
    191
    0
    Location:
    Charlotte, NC
    Vehicle:
    2010 Prius
    Model:
    II
    No need the oil thats recomended is way better than higher weight dino oil. Plus if you went to a higher weight oil you will loose mpg.
     
    #7 adamace1, Jul 10, 2011
(You must log in or sign up to post here.)