1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Amp and Subwoofer install in my 2010

Discussion in 'Gen 3 Prius Audio and Electronics' started by Bash4, Jun 9, 2011.

  1. Bash4

    Bash4 Junior Member

    Joined:
    Mar 9, 2011
    16
    6
    0
    Location:
    Streator IL
    Vehicle:
    2010 Prius
    Model:
    Three
    Just had my rockford punch 800.2 and two kicker cvt 8" sub boxes installed. I got the idea from kmkremer who posted something similar. I was worried that one sub box would not be sufficent. So when I measured my cargo area I was very happy that two would fit perfectly side by side plus my amp. Also had a capacitor installed because of the small battery that the car has. These subs hit pretty hard for 8's. I'm very pleased with the sound. Almost sound like two tens. I had so much vibration from the cargo lid that I bought some 1/2 inch black door seal and placed it around the cargo tray. This solved the problem. No vibrations. My amp signal was taken from the rear six inch speaker. At first the installer hooked up to the rear tweeter but the signal was not strong enough to amplify. I spent $265 with install minus the amp I had. :rockon:I hope my picture works, check it out.
     

    Attached Files:

    • 069.jpg
      069.jpg
      File size:
      81.9 KB
      Views:
      1,253
    #1 Bash4, Jun 9, 2011
  2. spiderman

    spiderman wretched

    Joined:
    Jul 5, 2009
    7,543
    1,558
    0
    Location:
    Alaska
    Vehicle:
    2010 Prius
    Model:
    II
    Well that about fills up the tray. lol

    Looks good though. Does it really rock or is it just good fill-in?
     
    #2 spiderman, Jun 9, 2011
  3. Bash4

    Bash4 Junior Member

    Joined:
    Mar 9, 2011
    16
    6
    0
    Location:
    Streator IL
    Vehicle:
    2010 Prius
    Model:
    Three
    No, it rocks. Punches me in the back. I had two JL 10w3 in my TL and these hit about 50-60 percent of those. Very satisfied.
     
    #3 Bash4, Jun 9, 2011
  4. robby3

    robby3 Member

    Joined:
    Mar 25, 2011
    181
    24
    0
    Location:
    Switzerland
    Vehicle:
    2010 Prius
    Model:
    V
    Cool ! I just asked myself if I would have enough power to fully drive both subs. I'm using an Ampire digital 4-channel amp (4x 100W RMS) set to 3-channels (rear speakers 2x100W@4Ohm plus sub 1x200W@4Ohms) and wire the Kickers in parallel (1x400W@2Ohms then). You have installed a fan for the Punch but is it really necessary ?

    - Robby
     
    #4 robby3, Jun 11, 2011
  5. F8L

    F8L Protecting Habitat & AG Lands

    Joined:
    Aug 14, 2006
    19,011
    4,081
    50
    Location:
    Grass Valley, CA.
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Nice and stealthy! :)
     
    #5 F8L, Jun 11, 2011
  6. CPSDarren

    CPSDarren CPS Technician

    Joined:
    Aug 9, 2009
    533
    112
    0
    Location:
    Chicago
    Vehicle:
    2010 Prius
    Model:
    II
    That is a great stealth install!

    I am also impressed with the Kicker 8" box for its size.
     
    #6 CPSDarren, Jun 11, 2011
  7. Bash4

    Bash4 Junior Member

    Joined:
    Mar 9, 2011
    16
    6
    0
    Location:
    Streator IL
    Vehicle:
    2010 Prius
    Model:
    Three
    I'm not sure. I guess I should have tried it without for a couple of days. I had this amp in a trunk bridged pushing two jl 10w3 and after 20 minutes of full power the amp would shut down. So I've always had the fan on the amp. Also this amp is ten years old so I hope this helps preserve it.:rockon:
     
    #7 Bash4, Jun 11, 2011
  8. F8L

    F8L Protecting Habitat & AG Lands

    Joined:
    Aug 14, 2006
    19,011
    4,081
    50
    Location:
    Grass Valley, CA.
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    You're likely running too low of an ohm load. The Rockfords that were rated for 2ohm did note like to be bridged at 2ohm because it is like running 1ohm and they would overheat. So unless an amp is rated at 2 ohm bridged, assume the 2ohm rating is stereo and only bridge it if you are running a 4 or 8 ohm load.
     
    #8 F8L, Jun 11, 2011
  9. LulzChicken

    LulzChicken Prius Enthusiast

    Joined:
    Jul 19, 2009
    791
    135
    0
    Location:
    Alabama
    Vehicle:
    2010 Prius
    Model:
    II
    -edit delete-
     
    #9 LulzChicken, Jun 13, 2011
  10. kmkremer

    kmkremer Member

    Joined:
    Jul 13, 2009
    227
    30
    0
    Location:
    San Diego
    Vehicle:
    2010 Prius
    Model:
    V
    Nice job Bash4!
     
    #10 kmkremer, Jun 13, 2011
  11. Hdarji23

    Hdarji23 New Member

    Joined:
    Jun 13, 2011
    6
    0
    0
    Location:
    New Jersey
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Thats pretty cool! You should go take my survey!
     
    #11 Hdarji23, Jun 13, 2011
(You must log in or sign up to post here.)