1. Attachments are working again! Check out this thread for more details and to report any other bugs.

blink home L2 + PIP ?

Discussion in 'Gen 1 Prius Plug-in 2012-2015' started by pfile, Mar 24, 2012.

  1. pfile

    pfile Member

    Joined:
    Dec 28, 2005
    319
    35
    0
    Location:
    bay area, ca
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    anyone else charging their PIP with a blink L2 EVSE?

    i'm finding that my blink keeps crashing over and over again but i can't say it's due to the prius. it might just be on the ... blink again (har har)

    also the prius reports that the charging power is "only" 1.9KW. it's probably a FAQ but is that the proper on-board charger capacity? i think the blink can deliver 3.6KW max.
     
  2. margie100

    margie100 New Member

    Joined:
    Jan 15, 2011
    4
    1
    0
    Location:
    Silicon Valley
    Vehicle:
    2012 Prius Plug-in
    Model:
    N/A
    We are charging our PIP with the Blink we got from the EV Project for our LEAF. We haven't had any issues. We typically use the PIP Charging Timer to start charging at 5am. Occasionally we charge immediately if we are going out again on the same day. We don't use any settings on the Blink.
     
    1 person likes this.
  3. pfile

    pfile Member

    Joined:
    Dec 28, 2005
    319
    35
    0
    Location:
    bay area, ca
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    me neither, the blink is set to always on and the timers are set in the leaf.

    after a few crashes the blink seems to have come up.

    anyone know if the 1.9KW charge rate is normal?
     
  4. ryogajyc

    ryogajyc Active Member

    Joined:
    Aug 30, 2004
    985
    165
    0
    Location:
    Reseda, CA
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Advanced
    The charge power is limited by the Prius Plug-in's charger. It takes about 3kWh of energy to charge the battery, so 3kWh/1.9kW = 1.6 hours to fully charge, which is consistent with the ~1.5 hours that Toyota says it takes to charge with an L2 EVSE.
     
  5. pfile

    pfile Member

    Joined:
    Dec 28, 2005
    319
    35
    0
    Location:
    bay area, ca
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base

    so the reported 4.4kwh battery capacity is the "raw" capacity that Toyota never actually fully uses, per their 80-20 (or thereabouts) battery management?
     
  6. ryogajyc

    ryogajyc Active Member

    Joined:
    Aug 30, 2004
    985
    165
    0
    Location:
    Reseda, CA
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Advanced
    4.4 kWh is the full battery capacity. It takes about ~3.2-3.3 kWh to charge the battery using 120V based on measurements with a Kill-a-Watt power meter. With ~85% charging efficiency, that means the actual usable capacity is ~2.7 kWh. I don't know what the lower and upper SOC ranges are, but 20-80% sounds reasonable.
     
    1 person likes this.
  7. jbrad4

    jbrad4 Active Member

    Joined:
    Jul 20, 2011
    474
    148
    11
    Location:
    Rowlett, TX
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Advanced
    Someone has already measured the EV SoC range (I forget who)
    Low is 25%
    Hight is 85.1%

    [Added:] 85.1 % came from here.
     
    1 person likes this.
  8. OilFreedom

    OilFreedom New Member

    Joined:
    Oct 21, 2011
    79
    25
    0
    Location:
    San Diego, CA (Carmel Valley)
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    pfile, has your Blink been updated to the new firmware release (2.0.20120112 / E1.10)? Mine was updated around the beginning of February, and it has been more stable since then. Our PiP isn't here yet (this week!), so I haven't had the opportunity to charge it with the Blink yet.