The Tanabe "Sustec" TUB153F two point front chassis bar fits perfectly on the "v"

Thanks for the kind words.

I only drove once after the installation but when I came to the almost elbow curve where I pass everyday, I gave it more speed and felt less body roll and the turn seemed a little quicker and truer than what I tried to memorize when I passed by that curve in the past few days. On straight away over bumps and puddles, I think the wheels planted firmer and not as bloated as before.

I need to drive more to be any more conclusive though.

 

Thanks..

I scrubbed them well with the green Scott-Bright and wiped off the aluminum dust with the micro fiber cloth. No primer but 5 coats and air dry between each coat. I was thinking of putting a clear high heat enamel on top but they are glossy enough. I sprayed inside the tube too.
I want to go back and see if I can add any more braces in the rear!
It felt good driving knowing that you have solid braces there. :mod:

 

I don't have a 19mm socket, but after consulting a handy online metric converter, a 3/4" SAE socket will work. In fact, most wheel lug wrenches have dual markings on them for Metric/SAE that includes the 19mm-3/4inch end.

 

Yes, I also used the 3/4 socket.

 

2012 2013 TOYOTA PRIUS ZVW30 ZVW35 DOOR UNDER FLOOR SUPPORT BAR JDM VIP JAPAN | eBay

Mike,

Have you seen this one?
I think it is of poor design, especially at the welding joints.

Tanasit