1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Help, Ruptured My Prius!

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by wbray123, Mar 22, 2014.

  1. wbray123

    wbray123 Junior Member

    Joined:
    Nov 20, 2011
    71
    9
    0
    Location:
    Colonial Heights, VA
    Vehicle:
    2013 Prius
    Model:
    Four
    Today I parked beside a curb in a parking lot and turned too tight. My rear wheel went on the curb and I backed off at a very low speed. But the car fell on the curb somehow and the passenger side undercarriage got busted up below the front door. Two holes about the size of my fist and a dangling piece that I need to deal with. So, should I repair this? Or just live with it (except for the dangling piece)? Is there an aftermarket piece that would cover it up cheaper than a real repair? Am mainly concerned about rust/corrosion and resale value. It's a new 2013 with 11,000 miles. Car.JPG Car2.JPG Thanks.
     

    Attached Files:

    • Car3.JPG
      Car3.JPG
      File size:
      117.6 KB
      Views:
      457
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,463
    8,377
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    It's lucky this damage is under your car, you can ignore it and nobody will know it's damaged. You can possibly use a strong epoxy type glue to glue back the piece that's dangling.

    SM-N900P ?
     
  3. Mike500

    Mike500 Senior Member

    Joined:
    Mar 1, 2012
    2,593
    763
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
  4. vskid3

    vskid3 Active Member

    Joined:
    Jun 23, 2013
    773
    228
    0
    Location:
    Texas
    Vehicle:
    2005 Prius
    OP doesn't have a C.

    From what's shown in the pictures, there shouldn't be any issues with rust. I would just do like JC91006 said and try to glue the dangling piece up. do not know if it would hurt resale value, mainly depends on how visible it is and how close the buyer inspects the car and how much they care. I wouldn't worry about putting any money into it until you're trying to sell it (or if it bugs you). For all you know, you could fix it and then have something else break the piece again.
     
  5. Mike500

    Mike500 Senior Member

    Joined:
    Mar 1, 2012
    2,593
    763
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
  6. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    107,571
    48,862
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    looks like fibreglas, is it plastique?
     
  7. Mike500

    Mike500 Senior Member

    Joined:
    Mar 1, 2012
    2,593
    763
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
    The parts are actually made of acrylonitrilebutadienestyrene. The abbreviation isABS.:)
     
  8. jhinsc

    jhinsc Senior Member

    Joined:
    Nov 25, 2010
    1,167
    259
    0
    Location:
    South Carolina
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    If you bought your Prius, you can wait to repair or not repair at all. If you leased it, you will have repair before the end of the lease.
     
  9. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,463
    8,377
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
  10. milkman44

    milkman44 Active Member

    Joined:
    Oct 16, 2011
    591
    386
    0
    Location:
    Ky
    Vehicle:
    2010 Prius
    Model:
    II
    That won't show if you glue it back, possibly back it up with some material on the inside. That sill will come off really easy, pop out about four plastic plugs and a couple of screws with a 10mm socket and it should be easy to clean and repair. The wife scratched the left door sill on a curb and I took both sides off and covered them with a sheet of red carbon fiber pattern film. I'll have to re do them as the plastic film has faded to pink, can't have that on a manly Prius.:eek:
     
  11. Skateruk

    Skateruk Member

    Joined:
    Nov 13, 2013
    125
    28
    0
    Location:
    Nottingham, UK
    Vehicle:
    2009 Prius
    Model:
    III
    Get it repaired and water tight as soon as you can otherwise if rust gets into any steel sections you'll get real big problems further down the line.
     
  12. The Electric Me

    The Electric Me Go Speed Go!

    Joined:
    May 22, 2009
    9,083
    5,795
    0
    Location:
    Undisclosed Location
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    My two cents is that I'd attempt gluing it.
    Just because it's not visible, and just needs to be "put back".

    A full out repair for that piece could get costly.

    Bodywork is just so expensive that getting it "officially" fixed could become a costly enterprise.

    It's kind of up to the OP what level of restoration they will be happy with. If just getting the piece back in place is the goal, then I think there are numerous grass roots options that would be less expensive than a full out part replacement and/or body shop repair.
     
    jhinsc likes this.
  13. trentofdestiny

    trentofdestiny Master Finagler

    Joined:
    Aug 8, 2011
    1,104
    225
    0
    Location:
    Harrisburg, PA
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    Maybe a used one from eBay, already the proper color? That would be my first choice. Second choice would be to take a utility knife and cut off the dangler. From a body professionals' point of view, unless you're plastic welding it, it's not a permanent repair.
     
  14. wbray123

    wbray123 Junior Member

    Joined:
    Nov 20, 2011
    71
    9
    0
    Location:
    Colonial Heights, VA
    Vehicle:
    2013 Prius
    Model:
    Four
    Thanks to all. Have cut off the dangling piece and there is no damage visible unless you look under the car. There are holes and fractures in the plastic piece down there so it will not be a simple patch. But will look into patching it later.
     
  15. adamace1

    adamace1 Senior Member

    Joined:
    Jun 22, 2009
    1,403
    191
    0
    Location:
    Charlotte, NC
    Vehicle:
    2010 Prius
    Model:
    II
    That will not cause any rust problems. It's up to you what you want to do.