Readiness codes after HV battery replacement

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by smafixer, Mar 14, 2017.

  1. smafixer

    smafixer Junior Member

    Joined:
    Sep 21, 2008
    3
    0
    0
    Location:
    Roanoke VA
    Vehicle:
    2007 Prius
    Hey folks first time posting, I've just replaced the hv battery on my 07 after reading all I could on here and watching a bunch of youtube. Decided to go with a new Toyota rather than referb. Red triangle went away but now I've got a bunch of Toyota Readiness codes that won't go away. P1E03, P0171, P3200, P0038, P0001, P0102, P0301, P0120, P2101, P0123, P2501, P0220, P02202, P0325, P3503, P0341
    The new battery didn't come with new electronics to my surprise so I had to swap them from the old one.
    I'm scanning with and Innova 3130 and it says all the codes are erased but obviously not.

    The car will run go into gear etc.

    Any ideas? Help?
    thanks!
     
    #1 smafixer, Mar 14, 2017
  2. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,210
    6,514
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    Did you try disconnecting the 12V battery? If it was not disconnected when you were installing the new traction battery, that should be done now, for a few minutes to let the ECU's reset.
     
    #2 Patrick Wong, Mar 14, 2017
  3. smafixer

    smafixer Junior Member

    Joined:
    Sep 21, 2008
    3
    0
    0
    Location:
    Roanoke VA
    Vehicle:
    2007 Prius
    I had it disconnected but I'll try it again, thanks
     
    #3 smafixer, Mar 14, 2017
  4. smafixer

    smafixer Junior Member

    Joined:
    Sep 21, 2008
    3
    0
    0
    Location:
    Roanoke VA
    Vehicle:
    2007 Prius
    Thanks Patrick that did the trick!
     
    #4 smafixer, Mar 14, 2017
(You must log in or sign up to post here.)