1. Attachments are working again! Check out this thread for more details and to report any other bugs.

2018 Prius c three tangerine splash pearl

Discussion in 'Prius c Technical Discussion' started by Subaru, Jan 26, 2019.

  1. Subaru

    Subaru New Member

    Joined:
    Jan 26, 2019
    8
    2
    0
    Location:
    Indianapolis
    Vehicle:
    2018 Prius c
    Model:
    Three
    Hi all, I just purchased a used 2018 Prius c and had a couple questions:

    1) what is the model(?) code? NHP10H?
    2) it came with a front license plate holder already installed. However, Indiana does not required front plates. Unfortunately, when I removed the plate holder there were 4 large holes. We’re there originally plugs there that I can order? I think I found some plugs for the two smaller screw holes.
     

    Attached Files:

    #1 Subaru, Jan 26, 2019
  2. Leadfoot J. McCoalroller

    Leadfoot J. McCoalroller Senior Member

    Joined:
    May 12, 2018
    6,800
    6,452
    1
    Location:
    Pennsylvania
    Vehicle:
    2018 Prius c
    Model:
    Two
    NHP10 is the model code. I haven't noticed it with an H on the end.

    You can get round bumper plugs in matching colors but I don't know of anyone producing plugs to fit the contour cuts for the upper mounting holes. (We don't use front plates in PA either)

    You may be able to get oversize round plugs and hand-trim them to fit, or even re-cut the bumper cover cuts to be round for better fit. I hadn't thought about that until just now.

    Ultimately we decided the best solution for us was to keep the bracket and hang a decorative plate.

    Welcome & good luck!
     
    #2 Leadfoot J. McCoalroller, Jan 27, 2019
    Subaru likes this.
  3. Subaru

    Subaru New Member

    Joined:
    Jan 26, 2019
    8
    2
    0
    Location:
    Indianapolis
    Vehicle:
    2018 Prius c
    Model:
    Three
    Update, I bought some plugs in black and some color match paint. I’ll have to trim the holes a little but should look better when completed. I’ll post a picture when done.
     

    Attached Files:

    #3 Subaru, Feb 9, 2019
  4. dubit

    dubit Senior Member

    Joined:
    Dec 3, 2016
    850
    538
    23
    Location:
    Indiana
    Vehicle:
    2016 Prius c
    Model:
    Two
    Hey congrats on the "C". Hope you enjoy it. I took mine out for a long drive this weekend all the way up to Peru. For about 3 or 4 minutes I was right behind a driver in the right lane on 465 also in an Orange C. They seem to be a bit rare around here as I've only ever seen a handful of Orange ones. Who knows maybe that was you.
     
    #4 dubit, Feb 10, 2019
  5. Subaru

    Subaru New Member

    Joined:
    Jan 26, 2019
    8
    2
    0
    Location:
    Indianapolis
    Vehicle:
    2018 Prius c
    Model:
    Three
    Ha, not me. I haven’t driven it much yet. I’m planning some mods before I make it my daily. Suspension, clear bra, fogs, side skirts, splitters, underbody work...and was thinking about silver racing stripes...lol. Just to make it a little fun project. Wish i could pull a little more torque out of the motor. So easy to do on my boosted Subaru. What about sticking a resistor in the feed to to Ecu signal for motor output/current demand from the battery it might trick the ECU to supply more power...idk
     
    #5 Subaru, Feb 10, 2019
    Last edited: Feb 10, 2019
  6. Leadfoot J. McCoalroller

    Leadfoot J. McCoalroller Senior Member

    Joined:
    May 12, 2018
    6,800
    6,452
    1
    Location:
    Pennsylvania
    Vehicle:
    2018 Prius c
    Model:
    Two

    Theoretically the car can be re-programmed to allow a deeper draw against the battery during acceleration. Naturally this would result in longer engine-on cycles and the MPG would drop accordingly. That's also going to cause more heating in the battery, which is vented to the cabin. In summer weather it would increase air conditioning demand.

    The extra electrical load and associated heat load would reduce the overall life of the traction battery. Tough to say how much impact, but if you are used to tuning Subarus then you probably already know what it is like to buy a multi-thousand dollar part a bit earlier than usual.

    Somebody managed to get a little extra by installing extra conductors around the shunts for the MG2 motor. Basically it fakes out the ECU into thinking it isn't delivering quite enough current to the motor, so it puts a little extra mustard on.
     
    #6 Leadfoot J. McCoalroller, Feb 10, 2019
    Subaru likes this.
  7. Subaru

    Subaru New Member

    Joined:
    Jan 26, 2019
    8
    2
    0
    Location:
    Indianapolis
    Vehicle:
    2018 Prius c
    Model:
    Three
    Looks better. I’ll have to clean it up when the weather is warmer...
     

    Attached Files:

    #7 Subaru, Feb 14, 2019
    michael.sfo and dubit like this.
  8. ztanos

    ztanos All-around Geek!

    Joined:
    Jan 10, 2013
    3,339
    1,149
    40
    Location:
    Cumming, Georgia
    Vehicle:
    2012 Prius c
    Model:
    Four
    Did you not just want to buy the black insert that comes with the cars?

    These look good, though!
     
    #8 ztanos, Feb 15, 2019
  9. Leadfoot J. McCoalroller

    Leadfoot J. McCoalroller Senior Member

    Joined:
    May 12, 2018
    6,800
    6,452
    1
    Location:
    Pennsylvania
    Vehicle:
    2018 Prius c
    Model:
    Two
    Now that I see it on the car I think you've missed an opportunity for a spider's worth of googly eyes.
     
    #9 Leadfoot J. McCoalroller, Feb 15, 2019
(You must log in or sign up to post here.)