1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Bad Axle Gen4

Discussion in 'Gen 4 Prius Main Forum' started by JObe, Mar 21, 2020.

  1. JObe

    JObe Junior Member

    Joined:
    Dec 16, 2019
    13
    6
    0
    Location:
    Ventura, CA
    Vehicle:
    2016 Prius
    Model:
    Two
    I've had a clicking noise from the front when I apply brakes, asked dealer to check it during my routine service (certified pre-owned, warranty service for 12mos). 35k miles on 2016 Prius. Turns out front left axle was bad, they replaced (1.7hrs) under warranty. Is this normal? Do Prius axles go bad? I've had car for 3months, approx 7k miles. I'm new to the Prius world. TIA
     
  2. priusman09

    priusman09 I used to be a TDI

    Joined:
    May 23, 2010
    67
    76
    0
    Location:
    wisconsin
    Vehicle:
    2009 Prius
    Model:
    N/A
    My 2009 had no issues with axels in 225,000+ miles. I did do a front wheel bearing at 110k and the second at 187,000. Come to think of it.....those were the only 2 repairs I had with the car- Period
     
    pjksr02 likes this.
  3. alanclarkeau

    alanclarkeau Senior Member

    Joined:
    Feb 24, 2016
    7,041
    7,580
    0
    Location:
    near Brisbane, Australia
    Vehicle:
    2016 Prius
    Model:
    N/A
    Search PRIUSCHAT - I recall maybe ½ dozen reported.
     
    JObe and Elektroingenieur like this.
  4. Elektroingenieur

    Elektroingenieur Senior Member

    Joined:
    Jan 8, 2017
    2,515
    3,253
    9
    Location:
    California
    Vehicle:
    2016 Prius
    Model:
    Three Touring
    JObe and alanclarkeau like this.
  5. JObe

    JObe Junior Member

    Joined:
    Dec 16, 2019
    13
    6
    0
    Location:
    Ventura, CA
    Vehicle:
    2016 Prius
    Model:
    Two
    Perfect. I searched before I posted, didn't find that thread. Just finished reading through it, it thoroughly covers my issue. Thank you!
     
  6. robsnyder20

    robsnyder20 Active Member

    Joined:
    Aug 13, 2012
    372
    300
    0
    Location:
    SW Florida USA
    Vehicle:
    2016 Prius
    Model:
    Three
    I had my 2016 prius axle replaced twice, one at 35k and one at 60k. I believe most people don't hear it if it does occur and someone with three other prior priuis's said his all did it, but caused no issues in previous models. This is my first Prius and I noticed it. So far cross my fingers the noise has not yet returned the third time but this issue is only covered to 60k under factory warranty.
     
  7. pianewman

    pianewman Active Member

    Joined:
    Dec 17, 2019
    264
    183
    0
    Location:
    DallasFortWorthTEXASregion
    Vehicle:
    2018 Prius
    Model:
    Two
    SW Florida? I know the Bradenton/Sarasota rather well, I don't recall road surface issues (potholes, expansion cracks) Any idea why your car would have 2 failed FE axles? One on each side, or on the same side?
    OEM 15"s?

    I've just scanned the 13 page "Clicking sound on regen braking" thread. Any idea if Toyota changed CV joint vendors, or perhaps they changed the quantity/quality of the CV joint lube?

    Thanks!
     
  8. Raphael Muscarelle

    Raphael Muscarelle Active Member

    Joined:
    Jul 18, 2018
    661
    222
    0
    Location:
    Cape Canaveral Floridia
    Vehicle:
    2011 Prius
    Model:
    Three
    What is not normal is when you say clicking noise happens. CV joints in my experience and commonly known to click during turns not breaking. Could be mechanics takeing advantage of warranty. NOT the first time I've seen this. I knew some dealer mechanics that would replace a fuse and tell manufacturer it was shorted wire and dash had to come apart.

    Posted via the PriusChat mobile app.
     
  9. pianewman

    pianewman Active Member

    Joined:
    Dec 17, 2019
    264
    183
    0
    Location:
    DallasFortWorthTEXASregion
    Vehicle:
    2018 Prius
    Model:
    Two
    I don't have this problem, but I'm a proactive (neurotic/OCD) car owner who likes to learn/know about possible weaknesses.

    I agree with you that normally CV failure/clicking is noticed while turning. In the extensive thread about this, someone(s) mentioned the possibility that the regen braking causes a different kind of torque to the shaft. It sounds sketchy to me, but maybe it's possible?

    I'd like to know what part of the axle assembly is making the sound? Is it actually the CV joint?
     
  10. Raphael Muscarelle

    Raphael Muscarelle Active Member

    Joined:
    Jul 18, 2018
    661
    222
    0
    Location:
    Cape Canaveral Floridia
    Vehicle:
    2011 Prius
    Model:
    Three
    The CV joint itself. There is caged ball-bearing fixed to the shaft then slid into sized channels on end piece. The channels and bearings ware and then start clicking.
    Posted via the PriusChat mobile app.
     
  11. robsnyder20

    robsnyder20 Active Member

    Joined:
    Aug 13, 2012
    372
    300
    0
    Location:
    SW Florida USA
    Vehicle:
    2016 Prius
    Model:
    Three
    I drive pretty easy in the SW florida area (no real potholes issue here). Normally back and fourth on US41 for roughly 30 miles each way for my commute. I wouldn't say its a failure but more of a noise that wasn't there before and I am proactive and notice odd noises ahead of time. Most of the mechanics wouldn't even hear it till I recorded the noise on my phone and cranked it up in the car (took several visits both times to get them to do the repair). I can say it makes more of a whirling sound now than when it makes the clicking noise. Now that I am out of warranty I can say I am not going to pay the $800 to get it fixed anymore unless there is a real failure of the axle itself. FYI the clicking noise does NOT occur when shifting into neutral and using friction brakes.
     
  12. pianewman

    pianewman Active Member

    Joined:
    Dec 17, 2019
    264
    183
    0
    Location:
    DallasFortWorthTEXASregion
    Vehicle:
    2018 Prius
    Model:
    Two
    Continued clarification is appreciated. Still speculating if Toyota changed vendors, if they modified the design (not likely, except maybe specified harder steel from the vendor?), or have installed a thicker lube, which would dampen what seems for some to be a naturally occurring clicking? Curious minds want to know...
    If this is simply an axle/CV replacement, an indie shop should be able to do the repair for about 1/3 what your dealership is charging...IMHO, of course. (I haven't examined the drivetrain, is it more complicated than a traditional FE axle/CV?)
     
  13. GRich

    GRich Junior Member

    Joined:
    May 13, 2013
    28
    16
    0
    Vehicle:
    2012 Prius c
    Model:
    Three
    Had my driver side axle replaced at 34k. Took the dealer 5 tries to find the bad axle. No problems since.

    Posted via the PriusChat mobile app.
     
    Mendel Leisk likes this.
  14. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    54,473
    38,105
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    I'm sure there's more to that story, but doesn't sound good, considering there's only 4 wheels on the car, lol.
     
    alanclarkeau likes this.
  15. jim240

    jim240 Junior Member

    Joined:
    Sep 28, 2007
    24
    2
    0
    Location:
    Texas
    Vehicle:
    2007 Prius
    Reminds me of the look on my wife's face when she came out in the garage and her Rav4 was up in the air with all four wheels spinning while I was trying to find the bad wheel bearing with a stethoscope.
     
    Mendel Leisk and Raytheeagle like this.
  16. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    54,473
    38,105
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Which reminds me of The Exorcist, lol.