1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Backup camera cable length, CCD or CMOD w/ IR or LED etc..

Discussion in 'Gen 3 Prius Audio and Electronics' started by Tekken, Jul 15, 2021.

  1. Tekken

    Tekken Member

    Joined:
    Jul 9, 2019
    250
    74
    0
    Location:
    Los Angeles, California
    Vehicle:
    2013 Prius
    Model:
    Two
    Hi All

    Want to install backup camera on None Nav Unit and I have read the thread None Nav Unit installation. Few questions if you guys can help

    1, 17 foot RCA cable length enough ?
    2, CCD sensor w/ IR light or LED light camera?
    3, Camera Positive power from reverse light or must from unit?
     
  2. zerotosixtysomeday

    zerotosixtysomeday New Member

    Joined:
    Sep 5, 2021
    18
    5
    0
    Location:
    Boston
    Vehicle:
    2011 Prius
    Model:
    One
    Did you get any advice on this? I want to add a backup camera and new head unit to my 2011.
     
  3. Tekken

    Tekken Member

    Joined:
    Jul 9, 2019
    250
    74
    0
    Location:
    Los Angeles, California
    Vehicle:
    2013 Prius
    Model:
    Two
    No.. PriusChater are electrical retardant, included me LOL. Another than that, mechanically, are superb.
     
  4. burrito

    burrito Active Member

    Joined:
    Jul 25, 2021
    274
    114
    0
    Location:
    California
    Vehicle:
    2015 Prius
    Model:
    Two
    I have not installed a back up camera in a Prius, but I did install one in a 4-door Kia sedan. My opinion is that 17 feet should be enough. The light shouldn't be needed, as your white reverse lights should provide enough light at night time. As far as power source, it depends on where the image will show. Generally, aftermarket back up cameras tap into the reverse lights for power primarily because you want them to turn on when you shift into reverse. When you shift out of reverse, you don't need the camera image, so it turns off because there's now no power. This may be different if you're trying to display the image on the installed HU. In my case, I installed a rear-view mirror with a built-in screen, so I only wanted it to power on when I was in reverse.