1. Attachments are working again! Check out this thread for more details and to report any other bugs.

New HV battery, or something else? P300, P0A80, P3018, P0A84

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by BeoLurch, Jul 15, 2022.

  1. BeoLurch

    BeoLurch Junior Member

    Joined:
    Jul 12, 2021
    21
    1
    0
    Location:
    WA
    Vehicle:
    2006 Prius
    Model:
    II
    2008 Prius with 133k miles displaying codes P300-(123,388,389), P0A80, P3018, P0A84.

    While driving it seems like a loss of power to the engine. The engine fan turns on and runs really loud, while the accelerator doesnt respond to pushing on it. If I'm on an even road it can stay driving at about 30-40mph, but when I get to a complete stop or a hill it goes very slowly like 1-5 mph. Turning off the car used to work, but now it has become so frequent that I can't really drive it. Anyone know what this is called or what this is a symptom of? The SOC starts off at 1 bar in the purple and goes to full bars in the green after about a minute of driving. the SOC fluctuates a lot while driving. The car with exclamation point is on the MfD. AUX battery is reading 12v. I cleaned to battery fan, but it's still giving me the P0A84 code and when trying to test the battery fan speed on TSI it will not connect to the fan. I'm seeing the Cell block 8 (P3018) is at about 12-14v, so that is an issue... The HV battery most likely needs to be replaced, but I'm worried... Should the issue with the battery fan should be resolved first so that the new HV battery doesnt die prematurely?

    Take Care~
     
    #1 BeoLurch, Jul 15, 2022
    Last edited: Jul 15, 2022
  2. SFO

    SFO Senior Member

    Joined:
    Feb 7, 2017
    5,297
    4,235
    0
    Location:
    Northern California
    Vehicle:
    2007 Prius
    Model:
    N/A
    Yes. Consider replacing a module or two, then top balance or cycle the pack.

    Have you checked or cleaned the associated HV battery fan connection already?

    Try removing the sticker and place a drop or two of machine oil on the fan spindle (with or without removing the circlip first).

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]


    Check all of the connectors on the left end (drivers side) of the HV battery, including the the harness and HV battery ECU (below) :

    [​IMG]
     
  3. fotomoto

    fotomoto Senior Member

    Joined:
    Apr 22, 2009
    5,602
    3,778
    0
    Location:
    So. Texas
    Vehicle:
    Other Hybrid
    FAQ

    If an 08 with 133k is in good shape otherwise, get a new battery (OEM or aftermarket) for the most reliability, performance (power wise it will feel and perform new again), and the least amount of downtime (for many jobs this is usually incredibly important).

    Little funds, plenty of time, can afford for vehicle to be down for many days at a time? The Wack-a-mole approach of replacing the worst of the cells is often suggested (see above). This can cost as much as half of a new battery (aftermarket plugnplay solutions). I recommended (and practiced) this method many years ago but in 2022 (for a gen 2) I'd skip and get all new cells (aka new battery) or if you can find a complete, used but much newer HV pack. Sometimes one gets lucky and finds one for cheap for a complete swap but other owners and battery rebuilders/shops are always looking too.

    GOOD LUCK!
     
  4. mr_guy_mann

    mr_guy_mann Senior Member

    Joined:
    Sep 3, 2020
    3,430
    1,484
    0
    Location:
    NJ-USA
    Vehicle:
    2006 Prius
    Model:
    Four
    The battery fan does need to work (and you need to do something with the HV battery itself.)

    As mentioned, the connector near the fan itself commonly gets corroded from water leaks around the tailgate body frame. Then check the connection at the fan itself. Also might want to check the small relay that supplies power to the fan- in the wire harness attached to the air duct(?).

    The battery ecu monitors the negative control side of the fan motor. With the fan off there should be near 14V at the ecu. When the ecu commands the blower "on" at lower speeds, the blower module partially grounds (pulse width duty cycle) the negative circuit. So there should be around 8-12V on the (-) monitor circuit, with voltage decreasing as fan speed increases. At 100% on, there should near 0V.

    If the ecu doesn't see the voltage it expects (when it expects), then you get the P0A84.

    For the HV battery, you can go for a new set of modules, Toyota, newpriusbstteries.com, or maybe projectlithium.com.

    Almost any other replacement pack is likely some kind of "refurbished" (ie, used) modules. Maybe something ok, maybe something bad, nobody knows. Maybe the modules were tested, discharge - charge cycled, and matched to similar ones, or not- nobody knows. Expect a couple years at most, some don't last a month without problems. Understand the warranty because you will probably need it.

    Get a complete set of (hopefully good) modules from a later wrecked Prius and swap those in. Can be Gen2, Gen3, and some (non Li-ion) Gen4.

    DIY repair- swap modules, clean or replace busbars and harnesses as needed. Cycle the pack with grid charger or hobby chargers- or not.
    Use the search function as there are hundreds of posts covering this topic.

    Posted via the PriusChat mobile app.
     
    BeoLurch likes this.
  5. PriusCamper

    PriusCamper Senior Member

    Joined:
    Mar 3, 2012
    11,055
    4,498
    0
    Location:
    Pacific Northwest, USA
    Vehicle:
    2007 Prius
    Model:
    Two
    I live in your state's capitol and looks like @SFO and others have answered most of your questions. Hit me up if you need parts or need more help?
     
  6. BeoLurch

    BeoLurch Junior Member

    Joined:
    Jul 12, 2021
    21
    1
    0
    Location:
    WA
    Vehicle:
    2006 Prius
    Model:
    II
    I might need help pinpointing the problem with the battery fan. I'm not going to bother replacing cells or checking the harness... I'd rather just buy a new/refurbished battery. I plan on getting a refurbished battery from WA Hybrid Battery Repair LLC in Kent, WA. Have you had any experience with them? The connections to the battery fan that sfo showed looked good to me when I glanced at them, but I may need to take a closer look. I'm hoping its not a wire that got chewed or chafed.
     
  7. PriusCamper

    PriusCamper Senior Member

    Joined:
    Mar 3, 2012
    11,055
    4,498
    0
    Location:
    Pacific Northwest, USA
    Vehicle:
    2007 Prius
    Model:
    Two
    Refurbished batteries are good for 3 months to 3 years depending on the quality of equipment the rebuilder has. GreenTec seems to be the most popular in western Washington. And a new OEM or Project Lithium upgrade pack may cost more up front, but you can go a decade without much concern, as in fix it and forget it. Of course you'd have to pull the trigger on this one in less than a week because after that they'll be out of stock till November: https://projectlithium.com/?ref=9qLPw And OEM packs are backordered indefinitely as well.

    As for the fan, I have a spare one, but use it to run Prolong charger on packs that aren't in a car... If you pull it out and test it with 12v wires going directly to the plug socket that will confirm if it works or not.

    As for your symptoms of engine reving and lack of power, this is just the car detecting the bad module and going into safe mode that shuts down the hybrid system and turns on the fan full blast, which is another way to test the fan.

    Usually the first module you replace in a pack is the one that keeps the pack going the longest. Of course your pack will need reconditioning (aka: deep cycling ) to restore capacity too. Depending on how close you live from me, I may be able to help with a spare pack, but would have to build it. Or could repair yours...