1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Hear me out....

Discussion in 'Gen 2 Prius Accessories & Modifications' started by sam jordan, Jan 5, 2024.

  1. sam jordan

    sam jordan Junior Member

    Joined:
    Dec 5, 2012
    21
    6
    0
    Vehicle:
    2003 Prius
    Model:
    ----USA----
    I saw a gen 2 Prius today with a class 2 hitch and I started thinking. I wanted to know if I can transport my dirt bike via a motorcycle carrier.

    U-haul offers a 2" receiver with 300 lbs tounge weight capacity. Best I can tell is the Prius can tow roughly 1k lbs....

    My dirt bike is right at 300 lbs...
    My hitch carrier is roughly 75 lbs...

    A Prius would look awesome with a dirt bike strapped to the back....

    What say you fine gentlemen?
     
  2. Leadfoot J. McCoalroller

    Leadfoot J. McCoalroller Senior Member

    Joined:
    May 12, 2018
    7,164
    6,713
    1
    Location:
    Pennsylvania
    Vehicle:
    2018 Prius c
    Model:
    Two
    ...when bolted onto something that can itself handle 300lbs.

    The average unreinforced Prius is good for about 200, if you stick to paved roads anyway.

    And yes, the brakes can handle an overall combined payload of about 1000lbs including driver.
     
  3. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    55,539
    38,709
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Will your license plate be visible?
     
  4. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    23,956
    15,569
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    It's different with a trailer supporting its own weight on wheels, and a carrier just projecting out back from the hitch.

    A common way a hitch is attached on a Prius is by using the shipping hold-down bolt locations in the underbody "frame" rails, a foot or so forward of the bumper. Each "rail" has two bolt locations, a couple inches apart.

    So you might be attaching a hitch to those, with a carrier sticking a few feet beyond that, carrying 400 pounds of static load five feet out from the attachment point, which is bolt locations a couple inches (or a sixth of a foot) apart. So multiply the 400 pounds by about 5✕6, or 30, to see the 12,000 foot pounds of torque being put on the mounting location. (Ok, there are two rails, so 6,000 ft lb at each.) Before adding dynamic forces as you bounce down the road, and before some rambunctious kid chasing his buddy through a parking lot takes a running jump off the corner of your carrier for fun.

    I had a hitch like that on my Gen 1 and a paid somebody to weld extensions to it that ran a couple feet further forward along the car's rails to where a couple other existing holes conveniently were. Then I worried much less about those torques.

    Some hitches might install to the bumper reinforcement mounting locations instead, which sounds like a better plan.

    Toyota didn't start offering an official hitch until Gen 4, in Europe. If you look at the installation instructions for that, you take out the bumper reinforcement mounts and slide the hitch's arms forward into the hollow underbody rails, and then bolt it in place. That looks like a pretty good design.
     
  5. sam jordan

    sam jordan Junior Member

    Joined:
    Dec 5, 2012
    21
    6
    0
    Vehicle:
    2003 Prius
    Model:
    ----USA----
    I like the thought of adding a little more substance and tieing back into the bumper mounts. I'll definitely look into this.
     
  6. sam jordan

    sam jordan Junior Member

    Joined:
    Dec 5, 2012
    21
    6
    0
    Vehicle:
    2003 Prius
    Model:
    ----USA----
    Not likely
     
    Mendel Leisk likes this.
  7. sam jordan

    sam jordan Junior Member

    Joined:
    Dec 5, 2012
    21
    6
    0
    Vehicle:
    2003 Prius
    Model:
    ----USA----
    I think I recall the payload is rated at 900 lbs and tow capacity was 1000 lbs
     
  8. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    55,539
    38,709
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    And your turn signals, brake lights?

    This is my pet peeve...
     
  9. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    108,843
    49,446
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
  10. Leadfoot J. McCoalroller

    Leadfoot J. McCoalroller Senior Member

    Joined:
    May 12, 2018
    7,164
    6,713
    1
    Location:
    Pennsylvania
    Vehicle:
    2018 Prius c
    Model:
    Two
    They make the haul much simpler, an average Prius would have no difficulty at all pulling a bike on one of those, even with the cheapest 1-1/4" hitch and no special reinforcements.

    But they're a major pain in terms of storage, maintenance and registration.

    Now... renting a trailer like that gets you the best of both worlds, but isn't commonly available.
     
    #10 Leadfoot J. McCoalroller, Jan 6, 2024
    Last edited: Jan 6, 2024