1. Attachments are working again! Check out this thread for more details and to report any other bugs.

prime charging cable - plug end slightly damaged - can it be repaired?

Discussion in 'Prime Technical Discussion' started by Prican, Aug 11, 2024 at 3:29 PM.

  1. Prican

    Prican Junior Member

    Joined:
    Aug 31, 2018
    26
    3
    0
    Location:
    toronto
    Vehicle:
    2012 Prius
    Model:
    III
    I just got my 2019 prime. I asked the dealer to make sure the charging cable was included in the car. It sure was, andn the plug end is damaged. the charger itself works. of course I only noticed this when I took it home.

    I have replaced many 15A/12 gauge plugs in my life and have no problem replacing another one EXCEPT, the dealer is two hours away, and I don't know if I should ask for a replacement. I know the right thing to do is to get a replacement, but you know the way some dealers are. its not the only issue.

    i dont mind spending some money,It is easier than dealing with the dealership, but there are limits

    1. does anybody either know if the very end of the plug between the charging brick can be replaced?
    2. The cable is unusually thick and the gauge of the jacket is not written on the cable, only the wires inside are listed. Is anyone aware of the thickness of the whole cable itself, then I could search for a plug end.
    3. am i screwed?
    thanks
     

    Attached Files:

    #1 Prican, Aug 11, 2024 at 3:29 PM
    Last edited: Aug 11, 2024 at 3:35 PM
  2. BiomedO1

    BiomedO1 Senior Member

    Joined:
    Mar 27, 2021
    1,517
    815
    0
    Location:
    SacTown, Ca
    Vehicle:
    2021 Prius Prime
    Model:
    LE
    Someone has already spliced into it and had done a sloppy repair job at that!

    I don't know how they do warranties in Canada, but I would insist on a new or properly repaired one. That cable isn't going to "hold-up", if you try to charge outside - isn't waterproof by a long shot and you'll likely get shocked.

    Good Luck....
     
  3. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    109,155
    49,617
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    if the brick comes apart, it shouldn't be too hard to replace. i'd be comfortable with electric tape if not using outside.
     
  4. Prican

    Prican Junior Member

    Joined:
    Aug 31, 2018
    26
    3
    0
    Location:
    toronto
    Vehicle:
    2012 Prius
    Model:
    III
    Yes but the long-term damage is not an issue if i can replace the plug or everything upstream of the charger box.

    i dont know if it comes apart, or what spare part i could use.
    we plan on plugging this into our outlet, outside but never removing it.
     
  5. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    109,155
    49,617
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    yeah, outside, i suppose i'd want a good seal. what about that flexi rubber tape from a hardware store, might be waterproof.
     
  6. Prican

    Prican Junior Member

    Joined:
    Aug 31, 2018
    26
    3
    0
    Location:
    toronto
    Vehicle:
    2012 Prius
    Model:
    III
    i dont really want to go down the electric tape route.That is not a good long-term solution,And would recommend it to nobody. I do have self-sealing silicone tape but would never use it for repair of this type.

    as far as I can tell, the plug-in needs to be replaced, or everything upstream of the brick. if these things are not possible then maybe my dealer needs to do something,But I just don't see them saying yes because car dealerships.
     
    bisco likes this.
  7. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    109,155
    49,617
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    new ones are pretty reasonable on amazon/ebay