Misfiring After Egr And Intake cleaning.

So i just cleaned out the EGR system and intake manifold with the intake ports or valve ports while also replacing the spark plugs. Now the engine misfires. The first 2 starts it made a horrible clunk noise and shook a whole lot but i can admit it sounded great the first few seconds then it misfired then the clunk to a stall. I think i screwed up my injectors making this the problem as i grabbed a drill with a brass pipe cleaner and run that over the injectors without realizing after i did all the ports. I blocked off the valves with a rag and shoved it back there to collect all the carbon chunks when i pull it out. Also on top of that the engine runs with misfires happening of course but has no throttle response but idles until i put it into drive the engine turns off. Is this a safety feature by Toyota? The dash tells me hybrid system not working or turn off the vehicle. The codes i got from the check engine light are P3190, P0A0F (X2), C1259, C1310.

 

Thanks for the response. kind of just looking for insight as I'm new to working on vehicles. Was it dumb to do that to me vehicle yes but i don't have money for a professional to clean some oil and carbon off some metal. I put back the old spark plugs ran the same, some misfires and a full stall when put into gear. Giving the intake a good look and throttle body since it doesnt rev up with the pedal while in park.

 

I changed back to the original plugs to see if it was that but it indeed was not.