Gen 3 P410 transmission differential tapered roller bearing spec

Discussion in 'Gen 3 Prius Main Forum' started by nettrinity, Aug 3, 2026 at 12:37 PM.

Tags:
  1. nettrinity

    nettrinity Junior Member

    Joined:
    Nov 21, 2015
    18
    2
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2014 Prius
    Model:
    One
    I am trying to replace Gen 3 P410 transmission differential tapered roller bearing, but I can't find the spec. I had differential out, but the bearing is un-marked, no document available. Does anybody know this bearing spec?
    Here is the link to the image
    Image 20260803123444 19 87 — Postimages
     
    #1 nettrinity, Aug 3, 2026 at 12:37 PM
  2. Mendel Leisk

    Mendel Leisk MMX GEN III

    Joined:
    Oct 17, 2010
    61,521
    42,332
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring

    Attached Files:

    #2 Mendel Leisk, Aug 3, 2026 at 1:04 PM
  3. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    13,853
    2,515
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    The Toyota dealer can't look that up for you in 10 seconds no kidding
     
    #3 Tombukt2, Aug 3, 2026 at 1:07 PM
  4. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    13,853
    2,515
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    Do this is for diff. Do it require set up bearing pre load and all that like a reg vehicle diff? All that set up procedures in the manual correct? I have it for other rear ends but not this.
     
    #4 Tombukt2, Aug 3, 2026 at 1:10 PM
  5. nettrinity

    nettrinity Junior Member

    Joined:
    Nov 21, 2015
    18
    2
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2014 Prius
    Model:
    One
    Good illustration! Thank you! But I still can't find the tapper roller bearing spec on this illustration. Through physical measurement I found my roller tapper bearing is ID 50mm, OD 75mm, width 20mm. Not sure if it is enough. Anybody done this before?
     
    #5 nettrinity, Aug 3, 2026 at 3:10 PM
  6. nettrinity

    nettrinity Junior Member

    Joined:
    Nov 21, 2015
    18
    2
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2014 Prius
    Model:
    One
    No shim found in diff tappered roller bearing
     
    #6 nettrinity, Aug 3, 2026 at 3:10 PM
(You must log in or sign up to post here.)