1. Attachments are working again! Check out this thread for more details and to report any other bugs.

2002 Death Shudder

Discussion in 'Generation 1 Prius Discussion' started by jdrum3, Sep 28, 2010.

  1. jdrum3

    jdrum3 New Member

    Joined:
    Sep 28, 2010
    3
    0
    0
    Location:
    TN
    Vehicle:
    2002 Prius
    Model:
    N/A
    Hello all, I am a new poster and have been reading up on the wealth of knowledge here, especially for steering issues.
    I have a 2002 Prius that is in dealer for the death shudder with power steering. Here is issue, they replaced ECU and tell me that the new steering rack must be compatible with ECU and price is $2500??? Wow, anyway, I decided to order one online and was wondering if you think it will work? I tried to post link, but have to have more posts to post a link, so if you ebay and search it, $895 with lifetime warranty, guarantee, etc, etc...How can I be sure that part will be compatible with new ECU?
    It is amazing to me that the part would be over 2500 and the labor $288! I am more used to a $15 head gasket and $1000 labor; )
    Anyway, thoughts are appreciated!
     
  2. bwilson4web

    bwilson4web BMW i3 and Model 3

    Joined:
    Nov 25, 2005
    27,123
    15,389
    0
    Location:
    Huntsville AL
    Vehicle:
    2018 Tesla Model 3
    Model:
    Prime Plus


    So the steering was oscillating back and forth?
    You may have some difficulty getting the dealer to install a used part.

    WORKAROUND:

    • Pulls the main EPS relay/fuses - this converts the car into a manual steering. It will harder at slow speeds but you'll eliminate the 'wobblies.'
    The problem is usually in the torque sensors and the only known solution is to replace the steering gear which includes the steering shaft and torque sensors. I wish there were an alternative but that is pretty much the only permanent fix. However, it is a systemic weakness of this model, the mechanical torque sensors that can get 'noisy.'

    Daryl had a switch put in his dash that handles the control power to the EMPS. So he normally drives around with the unit powered off and an error light . . . a manual steering Prius. He has the option of turning it on when parking or at slow speeds when the power steering helps the most. But this is something folks in Alabama, independent folks, tend to do . . . <grins>

    Bob Wilson

    ps. If you are close to NC, Re-InVolt is a general, independent Prius shop and David Taylor is very reasonable. You might give him a call.
     
  3. atikovi

    atikovi Junior Member

    Joined:
    Aug 18, 2005
    61
    6
    0
    You might just want to ignore it if it only happens occasionally. My '02 did that a few years ago for about a year and then it never happened again. Could be a speck of dirt on a sensor that finally got dislodged.
     
  4. jdrum3

    jdrum3 New Member

    Joined:
    Sep 28, 2010
    3
    0
    0
    Location:
    TN
    Vehicle:
    2002 Prius
    Model:
    N/A
    Thanks for the info! I will let you know how
    this used/remfg part goes. Yes, severe oscillations
    in steering wheel. Here's hoping for compatability &
    reputable dealers.
     
  5. jdrum3

    jdrum3 New Member

    Joined:
    Sep 28, 2010
    3
    0
    0
    Location:
    TN
    Vehicle:
    2002 Prius
    Model:
    N/A
    Okay, so here it is, I ordered a refurb rack off ebay and it did not work or sync up with ecu. If others experience this problem I think you must get ecu and rack off same vehicle for most cost effective solution. Toyota has an update on the new ECU's and when you order the rack from Toyota, it also comes with the ECU for the $2500 price tag. It is fixed with Toyota dealer part but my wallet is not: (...We have a wheel bearing that is going next, so hopefully we can take a breath before that repair! Thanks for all the help here.
     
  6. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    23,277
    15,074
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    That's very interesting - I wonder what they changed between the rack and ECU? Could they have gone to Hall effect like the later models, or just conditioned the signal differently?

    Does anybody have the new rack+ECU who would like to make some electrical measurements as in this older post? (Those measurements were on an already sketchy rack so probably don't reflect what they're supposed to be.)

    -Chap
     
  7. bjustin

    bjustin New Member

    Joined:
    Dec 10, 2009
    27
    1
    0
    Location:
    seattle
    Vehicle:
    2002 Prius
    Model:
    N/A
    I replaced the steering rack and ECU on my 2002 prius. Both parts were pulled from the same salvaged vehicle, and the dealer STILL couldn't get the thing to work. I've been driving with manual steering (which isn't that bad) ever since. My girlfriend does think it's bad because she's not as strong (especially when parallel parking.) I've been thinking of calling Lucious Garage in San Fran to see if they have any other ideas on how to get the power steering back without paying an arm and a leg. I'd have loved to have rigged up something like Daryl did, but now the power steering is completely dead.
     
  8. atikovi

    atikovi Junior Member

    Joined:
    Aug 18, 2005
    61
    6
    0
    That's the problem with these older models and why I sold mine recently while it didn't have any issues yet. You always worry you are one expensive repair away from the car being basically "totalled." The steering rack, a battery pack or inverter goes bad and it costs more to fix than the car is worth. I think in your case I'd pump up the front tires to 50 or 60psi and just live with it.
     
  9. adric22

    adric22 Ev and Hybrid Enthusiast

    Joined:
    Apr 6, 2009
    642
    144
    2
    Location:
    Fort Worth, TX
    Vehicle:
    2018 Chevy Volt
    Model:
    Plug-in Advanced
    I don't know, the inverter wouldn't be that expensive with a used one. Even the battery isn't quite so bad if you can get a refurb. The steering rack is probably the most expensive of all to fix. But on the other hand, it is also the only one of the "big-3" problems that you can sort of live with.
     
  10. atikovi

    atikovi Junior Member

    Joined:
    Aug 18, 2005
    61
    6
    0
    Isn't that the very problem you're faced with right now? You bought a used steering rack and it doesn't work? Some parts are OK to buy used, Prius racks and inverters ain't. I sold my '02 with 153K for $5,300 a month ago which is probably a top price with those miles. Didn't want to take the chance of one of those big 3 repairs coming up when I see good Gen1's selling for $3-4K.
     
  11. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,198
    6,464
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    A reasonable course of action. I would add the transaxle to the list, making at least 4 big repairs that might be needed by a high-mileage Classic Prius. The transaxle is probably the most costly repair, at least in terms of required labor time.
     
  12. jk450

    jk450 New Member

    Joined:
    May 11, 2005
    596
    54
    0
    Forum member adric22 is right. As long as the inverter isn't physically damaged, it is not a particularly dangerous part to buy used. Many Gen I inverter replacements are the product of misdiagnosis.

    Gen 1 Prius steering racks are another story altogether.