1. Attachments are working again! Check out this thread for more details and to report any other bugs.

**UPDATED** Car died after leaving it with the valet...

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by Tall Rob, Nov 23, 2015.

  1. The Electric Me

    The Electric Me Go Speed Go!

    Joined:
    May 22, 2009
    9,083
    5,796
    0
    Location:
    Undisclosed Location
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Is this representative of one of the less often spoken realities of owning a Prius?

    That is the danger and fear whenever leaving a Prius in a "2nd Party" situation?

    Even when I leave my Prius for service at a Toyota Dealership, I have a twinge of angst in regards to wondering if it's being handled correctly.

    I've had to have some bodywork done on my Prius since owning it. Always a little apprehension in regards to wondering if it's being powered down correctly.

    Today push button starts and off, have become more and more common. You'd think even with the Hybrid operation most people could handle it.

    But every time I leave my Prius in a 2nd party situation I'm a little worried.

    When it comes to my Prius I'm Scar Face. Who do I trust? I trust ME!.
     
  2. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    107,785
    48,987
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    agreed. when we were at the marriott, fisherman's wharf in san francisco, i handed the valet my key fob. he said, 'there's no key on it'. i thought, 'uh-oh...'
     
  3. hlunde

    hlunde Member

    Joined:
    Dec 22, 2009
    419
    74
    1
    Location:
    NJ
    Vehicle:
    2010 Prius
    Model:
    III
    Some legacy jump starters operate at substantially more than 15V. These models are often mounted on tow trucks or on hand carts. I guess the objective is to start a vehicle whose starter or ignition system is in mediocre condition. A high-voltage, correct-polarity jump start would explain the headlamp failure since they are not polarity sensitive. And perhaps the blower control was just more sensitive to over-voltage than other electronics.