1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Shifter not working after Re and Re

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Frank Quigg, Mar 17, 2023.

  1. Frank Quigg

    Frank Quigg Junior Member

    Joined:
    Feb 23, 2022
    2
    1
    0
    Location:
    V4R0B6
    Vehicle:
    2007 Prius
    Model:
    Two
    Removed the shifter from 2006 Prius. It was working perfectly. Reinstalled it and now I get the P0705 code and it will not shift into gear. Neutral only.
     
    #1 Frank Quigg, Mar 17, 2023
  2. dolj

    dolj Senior Member

    Joined:
    May 14, 2012
    7,645
    3,858
    0
    Location:
    Wellington, New Zealand
    Vehicle:
    2007 Prius
    Model:
    N/A
    Recheck your work. The most probable cause is something was not reconnected or a connector did not "click" when connected
     
    #2 dolj, Mar 18, 2023
  3. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    108,822
    49,437
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    unfortunately, a lot of old toyota connectors cannot take re re. you may have to re (place)
     
    #3 bisco, Mar 18, 2023
  4. Frank Quigg

    Frank Quigg Junior Member

    Joined:
    Feb 23, 2022
    2
    1
    0
    Location:
    V4R0B6
    Vehicle:
    2007 Prius
    Model:
    Two
    Thank you for taking the time to help. I took it apart and checked the plugs. You were correct, even though the plug-in clicked what had happened was a pin got bent to one side and was not in the female plug. it was bent and had a kink in the middle so it took some careful unbending to get it lined up. Works perfectly now. Thanks again!!!!!

    Thank you for taking the time to help. I took it apart and checked the plugs. You were correct, even though the plug-in clicked what had happened was a pin got bent to one side and was not in the female plug. it was bent and had a kink in the middle so it took some careful unbending to get it lined up. Works perfectly now. Thanks again!!!!!

    Thanks for trying to help. Turned out a pin got bent and I was lucky this time.
     
    #4 Frank Quigg, Mar 20, 2023
    Last edited by a moderator: Mar 21, 2023
    bisco likes this.
(You must log in or sign up to post here.)