'08 factory EV button install question

Hello, I am in the middle of installing a factory EV button on the wife's '08 Prius. I purchased a button from japanparts and also ordered the connector 90980-10964 which I turned out to not need(This fits the older button pictured in the old writeups here on the PC). The button sent was 84720-47021 and they included the proper fitting connector 82824-21030 with it. The pins I harvested from the flasher connector under the steering wheel fit <strike>perfectly</strike>. I used 24gauge wire from a cat 5 cable and soldered into the pins and the 24gauge wire is the perfect fit. Need to go get some 3/32" shrink tubing.

My question is, even after rereading all the install guides again, what is the orientation of the wiring on the factory button switch? Where do the Illumination + and - go, and where do the ECU trigger and ground wires go. I believe the ECU goes in slot 3, IL+ in slot 1 and the grounds in the other two. Can someone please confirm the orientation from the top of the plug with the button oriented properly. Thank you.

 

Thanks! I kept looking and found evnut's install that lists the order of the newer button wires and I just now got done. It works but was a pain, literally. Was sporting three bandaids at one point, the wire took a while to fish, but the real difficulty was getting the pins fully seated. I gave up on the ones in the plug and they are sticking out a sixteenth of an inch or so. It lit up and the button triggered EV so done, just not happy the pins aren't seated. I used up all six I harvested from the flasher after breaking a wire off trying to push it's pin into the plug. I also copied shaving off the key on the sides of the button so I could put it in the far left hole.

 

Pin 1 - Switch ground - to a grounded bolt somewhere.
Pin 2 - Light ground - tap into gray wire on dimmer.
Pin 3 - Light +12V - Rheostat controlled - tapped into red wire on dimmer.
Pin 4 - Switch positive. Connect to pin 27 on the ECU

Since I can't post link yet here's the wiring order for the button plug.