1. Attachments are working again! Check out this thread for more details and to report any other bugs.

2013 Prius "Start" button light won't turn green/car won't start intermittently

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by ArthurC, Apr 16, 2024.

  1. ArthurC

    ArthurC New Member

    Joined:
    Apr 16, 2024
    2
    0
    0
    Location:
    CA
    Vehicle:
    2013 Prius
    Model:
    Two
    When I typically press the brake pedal, start button shows a green light and allows me to start the car when I push the button.

    1. I've recently had some intermittent issues where the "Start" button won't turn green and stays off even when I depress the brake pedal.

    2. After the third time I depress the brake, the Start button light will turn green, but I still won't be able to start the car - however, I'll hear a slight struggling 'whirring' noise unlike the one you usually hear. Brake can become a little stiff during this time.

    3. After depressing the brake pedal a fourth time, the light will not only turn green but I'll be able to start the car and run without issues.

    4. I wondered if it could be a brake light switch contact issue - however, one thing I noticed when I tried turning the Prius to accessory mode to do a 12v battery check was that the car was unable to turn to accessory mode (which does NOT require the brake pedal depress). After multiple button presses/brake pedal taps, the car started whirring a bit and was finally able to start up, after which I checked the 12v battery was at 12.2V when car was off/14V+ when car was running.
    This issue has come and gone randomly for a couple of months now, and always seems to go away after multiple attempts at the brake pedal - any idea why this is happening?

    Can brake switch light be an issue if the Prius cant even turn to accessory mode? And what could cause the Prius to not be able to switch to accessory mode if the 12v battery health check seems to be OK?

    Key fob battery is brand new so not key fob issue.
     
  2. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    107,874
    49,038
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    i would have the battery load tested for free at an auto parts store
     
  3. Brian1954

    Brian1954 Active Member

    Joined:
    Jan 31, 2021
    676
    256
    0
    Location:
    South Central PA, USA
    Vehicle:
    2011 Prius
    Model:
    III
    How old is the 12v battery?
     
  4. ArthurC

    ArthurC New Member

    Joined:
    Apr 16, 2024
    2
    0
    0
    Location:
    CA
    Vehicle:
    2013 Prius
    Model:
    Two
    Battery is likely 7-8 years old. I’m just confused as I would assume the car would just refuse to start altogether in case the battery was dead/dying, versus always being able to kick back up after trying to depress the brake pedal 3-4 times.
     
  5. Brian1954

    Brian1954 Active Member

    Joined:
    Jan 31, 2021
    676
    256
    0
    Location:
    South Central PA, USA
    Vehicle:
    2011 Prius
    Model:
    III
    It is time to replace the 12v battery.
     
  6. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    54,780
    38,294
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Wouldn’t hurt to test first, see where you’re at. At least check the voltage, first thing in morning, car off, with digital multimeter, post the reading.
     
  7. ASRDogman

    ASRDogman Senior Member

    Joined:
    May 29, 2018
    5,919
    3,171
    0
    Location:
    Florida
    Vehicle:
    2010 Prius
    Model:
    Two
    Likely the 12v battery life is ending, or has ended.
    When you open the door, the brake pump runs. If you listen for it when
    you get in the car, you'll notice it sounds difference, and will run longer and slower
    because the battery is weak. If you wait until it stops, then maybe 10-15 seconds,
    depress the brake pedal and listen for pump to run. If it doesn't press the start button.
    If it runs, wait for it to stop, then wait another 5-10 seconds before pressing the start button.
    Leave your foot on the brake pedal. The will probably start.
    But, it's time to replace the 12v battery, it's lived it's life well.
    Don't forget to charge the "new" battery for about 6 hours before installing it.

     
    Brian1954 likes this.