Prius gen 2 low hanging exhaust pipe?

Any exhaust guy I'll have that fixed up in 5 minutes No problem It's way too low needs to be heated and pushed up with the pipe holder let the exhaust guy uses I make them put mine up tight against the car but not touching anything so I can go over things without it ever scraping It should not be scraping It may also be getting time for springs and struts which has no bearing on this exhaust issue

 

@Has Raf can you clarify orientation/location of pic? Is that near the back, just behind engine, what side, it’s a front wheel or back wheel showing?

N’mind: as Tom says, hie thee to muffler shop.

 

Just name your car Wun Hung Lo

 

Something looks unusual with the bends on that pipe. I wonder if this car had its catalytic converter, etc stolen somewhere in it's recent life and it now has some aftermarket pieces installed? I've seen some where the new cat pipe is a clamp design and gets installed without actually positioning the downstream pipe correctly. Not everyone rotates the pipe prior to clamping to ensure the correct road clearance is maintained. If so, all it takes is loosening the clamp, put a pipe wrench or channel locks on each pipe and spin the downstream one just a fraction of an inch to make that section of pipe lift up.

I just don't know...something about that bend looks really odd where it disappears and should go to the resonator

 

It's just easier for the muffler guy to do it he has heating Jack and everything ready once the car's up it's like a 6-minute job It's almost embarrassing and then that suckers tucked up under there like it belongs there and yes prying jerking cutting with sawzalls. Can definitely wreak havoc on how everything hangs Make sure you check all your rubbers while you're up under there usually the muffler shop will have these most people aren't going to have them lying around and are not going to know what to look for when they walk into the help section at the auto parts store