2009 horn is stuck

Me personally I would be pulling the airbag off the middle of the steering wheel it's easy to do. You need to follow the precautions and removing the airbag it's the same for most vehicles probably going to want to have the power off want to be using plastic tools so we create no sparks blah blah blah The orange and black connectors on the back of the airbag steering pad horn button lift up and withdraw straight up there's a lock on the back of the orange part look carefully it lifts up and then the connector lifts off set that over on the floor on the passenger side I believe with the bag or the logo aimed to the floor or if you're that worried about it slide it under the seat if it was to go off it certainly not going to lift the seat off of its bolts but if it goes off while it's on the floor it could seriously hurt you We have never gotten one to blow up yet but use your safety thinking cap and then see what happens with that black wire that runs from the steering wheel harness to the lower portion and tang on the airbag module horn button. Does your horn button feel normal when you push it down or does it kind of stick when you have this off and unplugged then that little wire the black wire with the spade connector on it that's your horn button now you're holding in your hand You touch that to the center nut of the steering wheel the horn should honk then when you lift up that spade connector with your fingers from the center nut holding on the steering wheel the horn should stop Do it again touch it the horn goes off move it the horn stops again okay so that's working. When the metal tang is not touching any metal you have no horn when you touch it with your fingers to meddle and it grounds you have horn.? So something is wrong with the steering wheel springs on the center pad and airbag assembly see the springs on the four corners when it's flipped over you should be able to push those down and they don't stick or any funny business something seems to be wrong right in there. The key is is if you're horn works normally with you just touching the little silver metal spade on the end of the black wire If that works then your problem I would think would be ahead of that which would be the pad with the logo and the four springs

 

Make a test light that will plug into the horn plug and let the light be mounted somewhere it can be easily seen. Then you can do better troubleshooting without the horn making noise. Find out what making the light go out or turn on.