I replaced water pump and then removed negative battery cable to clear the code.. now all my warning lights all stay lit up on the dash and it won’t let me place car into drive or reverse.. I have tried reset this several times by same procedure with no luck.. I know I must of re set all defaults and lost communication with computer. Now I can’t even move the car.. how do I get this all synced again?
if you have trouble lights, you have more codes. could be related to the pump or the install. use tech stream or autel
Not more codes .. just everything on instrument panel is all lit up and I can’t get into drive or reverse.. it locks me out
Are you getting the green 'ready' lamp? It doesn't seem reasonable that you don't have any more codes and yet the car won't go into gear. Why would the ECU lock you out if everything is READY???????? Use a better OBD2 scanner....
Yes have green ready light.. and green light at start button but when I put into any gear it immediately turns amber and locks me out .. once I set parking brake again that light will turn back to geen
Ya know what.. when I plugged it back in.. I did t know to slide it to the right until it clicks.. seen that on another YouTube video.. everything works fine now… thank you guys so much for your time and input.. these forums rock
If the orange plug handle wasn't slid to the right, the code was P0A0D for the safety interlock circuit (that handle is part of that circuit). So reading the code would have identified the issue with no need to guess.
