Fumoto drain valve F133S install

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by xw20_driver, Jan 17, 2026 at 7:58 PM.

  1. xw20_driver

    xw20_driver Junior Member

    Joined:
    Feb 4, 2025
    94
    50
    0
    Location:
    PNW
    Vehicle:
    2007 Prius
    Model:
    Touring
    2007 Prius Touring with 206K miles. Performed an oil change today. Drained Pennzoil Ultra Platinum (PUP) 5w30 and replaced with Valvoline Restore & Protect 5w30. Hoping the Valvoline R&P will do some internal engine cleaning. Took the opportunity to install a Fumoto drain valve F133S replacing the factory drain bolt and washer.

    Instructions for the Fumoto drain valve is to hand tight. It comes with a blue fiber washer. After hand tightening, turn the valve using a crescent wrench 1/8 to 1/4 a turn. I tightened it about a 1/4 turn.

    fumoto01.jpg fumoto02.jpg fumoto03.jpg fumoto04.jpg yzzn1-21.jpg yzzn1-15.jpg
     
    #1 xw20_driver, Jan 17, 2026 at 7:58 PM
    Last edited: Jan 18, 2026 at 1:55 AM
  2. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    13,141
    2,360
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    Yes been using those for years they're great no issue in about twenty years or so . That valve has many iterations . Over the years . Makes oil changes a bit faster . No need ramps .
     
    #2 Tombukt2, Jan 17, 2026 at 10:31 PM
    xw20_driver likes this.
(You must log in or sign up to post here.)