Had p1116 and p1121 replaced coolant flow control valve and still have p1121 and no heat.

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Djsun1, Jul 8, 2026 at 6:12 PM.

  1. Djsun1

    Djsun1 Junior Member

    Joined:
    Jul 26, 2023
    3
    0
    0
    Location:
    Portland or
    Vehicle:
    2009 Prius
    Model:
    Touring
    Like title says I had both p1116 and p1121 codes. I replaced the coolant flow control valve with an OEM unit. Now I only get the 1 code, p1121. The heat is blowing ambient air, otherwise the car runs well.
    Not sure if this matters but when I cold start it 1st thing in the morning, I get a 3-5 second buzz-werr sound right after starting. Once the car warms up and I shut it down and start it up there is no sound.

    What else can I do to troubleshoot? Could it be a bad pump? How can I test for that?
     
    #1 Djsun1, Jul 8, 2026 at 6:12 PM
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,932
    8,640
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Check your coolant level in the radiator and make sure it’sfull
     
    #2 JC91006, Jul 8, 2026 at 11:02 PM
  3. 6079smithw

    6079smithw Junior Member

    Joined:
    Jan 12, 2024
    21
    7
    0
    Location:
    N. Nevada
    Vehicle:
    2009 Prius
    Model:
    Base
    What JC91006 said, plus did you bleed the heater loop using the ammeter routine after you replaced the valve ? Doesn't take much air in the heater core to make it quit. The bleed routine will also verify the electric pump is working. BTDT Good luck!
     
    #3 6079smithw, Jul 9, 2026 at 1:39 AM
(You must log in or sign up to post here.)