P3193 and P0A0F code

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Keith 770, Aug 8, 2026 at 8:48 PM.

  1. Keith 770

    Keith 770 New Member

    Joined:
    Thursday
    1
    0
    0
    Location:
    Ruther Glen, VA
    Vehicle:
    2007 Prius
    Model:
    Touring
    2007 Prius, lots of miles

    ADDED 7 Gallons of GAS by hand from a metered Gasoline bottle.
    The engine will not start
    The fuel pump sounds to be running when I jump it
    I swapped out the fuel relay

    The car reports one flashing bar of fuel (incorrectly) As the gas was flowing back onto the ground, it is safe to say it is FULL.

    I guess what I want to know is if the gauge sender fails and decides there is no fuel, does the computer shut the motor down and prevent the fuel pump from running?

    And so....
    If this is the case, unless I find a wiring issue, I will need to replace the gas tank (unless I can get to the sender) I know there are screws around the pump and the pump cannot be removed, but is it possible to get at the sensor sender?

    I omitted the other errors, such as replace hybrid battery...that might make mechanic shops salivate, but I have a full set of cell spares...it just got tired as my daughter did not sense the engine had stopped and drained it....any one have a hand crank charger?
     
  2. Brian1954

    Brian1954 Senior Member

    Joined:
    Jan 31, 2021
    2,681
    1,071
    0
    Location:
    South Central PA, USA
    Vehicle:
    2011 Prius
    Model:
    III
    No
    You need to determine the voltage of the hybrid battery. Use a scanner or a volt meter.