1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Rear Spoiler coming loose

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Jim Biggs, Jun 27, 2007.

  1. Jim Biggs

    Jim Biggs Junior Member

    Joined:
    Aug 12, 2004
    29
    0
    0
    Location:
    Scottsdale, AZ
    Vehicle:
    2005 Prius
    Model:
    Plug-in Base
    I drive a dirt road every day. I now find the rear spoiler is coming loose and there is an intermittent LOUD metal to metal noise in the back that I cannot find. There is no evidence of metal rubbing from underneath.

    1. Can someone tell me the disassembly / assembly procedure to open the hatchback and tighten the spoiler?
    2. Any ideas on the noise?
    Thanks
     
  2. JimN

    JimN Let the games begin!

    Joined:
    Nov 26, 2006
    7,028
    1,116
    0
    Location:
    South Jersey
    Vehicle:
    2010 Prius
    Model:
    V
    <div class='quotetop'>QUOTE(Jim Biggs @ Jun 27 2007, 11:14 PM) [snapback]469196[/snapback]</div>
    Is everything secure in the bin under the deck?
     
  3. Bill Merchant

    Bill Merchant absit invidia

    Joined:
    May 3, 2005
    4,096
    81
    13
    Location:
    USA | Oregon | Portland area | 97004 |
    Vehicle:
    2007 Prius
    If you are sure it's the spoiler and not another rattle, getting to its bolts is not that difficult.

    The large plastic panel on the interior of the hatch just push-clips to the metal of the hatch. Carefully pry it loose, starting at the lower, outer corners, and you can pull it off. You may have to yank with some force. There is one clip in the very center of the panel that is difficult to remove and impossible to reach in to pop the clip; you may break the attachment point, but it won't damage looks or functionality. Once you have the main panel off you can easily remove side panels if necessary. You can figure out which bolts extend in to the hatch frame from the spoiler and tighten them with a 10mm socket.

    If you see any leak stains on the inside, make sure you tighten enough in that area to stop future leaks. Better, loosen the bolts, remove the spoiler, put a dab of silicone caulk around the holes, and reinstall the spoiler.

    I don't know what model you have, but since you joined in 2004, I suspect it may be a 2004 car. This may be a good time to prophylactically replace the license plate lights.

    Reassembly involves popping the plastic connectors back into the holes they pulled out of.
     
  4. sounds_great

    sounds_great Junior Member

    Joined:
    Jul 6, 2006
    34
    1
    0
    Could you take it in for warranty repair?
     
  5. Manksgloob

    Manksgloob Member

    Joined:
    Mar 2, 2006
    243
    13
    0
    Location:
    California
    Vehicle:
    2006 Prius
    Model:
    N/A
    Check your rear license plate, too. Mine was rattling around for a while (and scratched through the paint, too :angry: )

    EDIT: Sorry, you said loud metal noise. Nevermind.
     
  6. Elephanthead

    Elephanthead Junior Member

    Joined:
    Jun 22, 2007
    72
    1
    0
    There are 4 bolts and 3 clips? How do the clips work? Is there anyway to make the thing more rigid? This is the one thing that bugs me about the prius, esp the touring one is extra huge and bouncy.
     
  7. Jim Biggs

    Jim Biggs Junior Member

    Joined:
    Aug 12, 2004
    29
    0
    0
    Location:
    Scottsdale, AZ
    Vehicle:
    2005 Prius
    Model:
    Plug-in Base
    As a followup. I have a 2005 Prius with 105,000 miles on it.
     
  8. Elephanthead

    Elephanthead Junior Member

    Joined:
    Jun 22, 2007
    72
    1
    0
    I don't think the noise is the spoiler, but after messing with mine, the clips/snaps on the outside corners do more to hold it secure then the bolts, You can easily tell if you have a clip problem, which I don't think you do, the spoiler will be much higher then the body side panel. The snaps/clips are rivited to the car, and the spoiler just snaps on. The bolts then secure it. I suspect as previously noted you have something loose in your spare tire hole.
     
  9. mastermason11

    mastermason11 New Member

    Joined:
    Aug 19, 2007
    5
    0
    0
    my spoiler is very loose and I can see that the plastic clips on the spoiler that attaches to the trunk are busted. Can this be part of the warranty ?
     
  10. patsparks

    patsparks An Aussie perspective

    Joined:
    Jul 12, 2007
    10,664
    567
    0
    Location:
    Adelaide South Australia
    Vehicle:
    2004 Prius
    Model:
    N/A
    I don't know if it's the cause but it's best not to use the spoiler to close the hatch. I find myself putting my hand up to the spoiler but trying hard to make using the hand hold in the inside of the hatch a habit.
     
  11. aforkosh

    aforkosh Active Member

    Joined:
    Jan 2, 2004
    395
    246
    0
    Location:
    Oakland, CA
    Vehicle:
    2023 Prius
    Model:
    Limited
    <div class='quotetop'>QUOTE(patsparks @ Aug 19 2007, 04:44 AM) [snapback]498603[/snapback]</div>
    The easiest way to close the car is to start by pulling down with inside handle and then lightly pushing against either the Toyota emblem in the center of the hatch or the license plate. It's amazing how much leverage there is using the emblem.
     
  12. usbseawolf2000

    usbseawolf2000 HSD PhD

    Joined:
    Sep 22, 2004
    14,487
    2,994
    0
    Location:
    Fort Lee, NJ
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    I just pull the inside handle and let go of it and the hatch closes on it's own momentum. Try it.
     
  13. Mauibound

    Mauibound New Member

    Joined:
    May 21, 2006
    64
    1
    0
    Location:
    Newport Coast, CA
    Vehicle:
    2006 Prius
    I have a similar issue. And I know for a fact that it's my spoiler. How do I know? Because I tried to back out of my garage with the trunk up. Woops. You'd think that seeing the top of the garage in my rear camera would have stopped me, but I was multi-tasking at the time.

    If the snaps/clips are rivited to the car, I'm assuming that this will be a very difficult issue to fix. Am I right? Can I just get new snaps/clips and snap it back in place without having to worry about welding something?
     
  14. theegg

    theegg Junior Member

    Joined:
    Jun 2, 2008
    18
    3
    3
    Location:
    Georgia
    Vehicle:
    2018 Prius
    Model:
    IV
    Glad you mentioned that. I'm super careful not to use the spoiler to close the hatch. I tug on the interior handle then put my palm on the emblem. No problems! I cringe everytime I see one of my son's friends use the spoiler as a handle!
     
  15. Speedwing

    Speedwing Junior Member

    Joined:
    May 9, 2008
    48
    11
    0
    Location:
    Southeast PA
    Vehicle:
    2008 Prius
    Luckily for me the Dealer did not mount my framed license plate. I placed 2 rubber "bumpers" in the 2 recessed dimples under the plate area on the hatch using 3M trim tape. Pushing on the license plate when closing the hatch is our normal routine. With the bumpers under the plate no plate to paint contact is possible. These bumpers should be a standard item for EVERY Prius to have under the plate. Home Depot has similar bumpers in the cabinet hardware section.
     
  16. robert562

    robert562 New Member

    Joined:
    Sep 3, 2010
    4
    0
    0
    Location:
    Cerritos
    Vehicle:
    2010 Prius
    Model:
    II
    I have a factory spoiler for a 2010 prius for sale. There's two small (less than an inch) scratches on it. I'm selling it for $250. Let me know if your intrested.