Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
How old is the 12v Battery? Have you tried to put a jumper either on the battery, or under the hood at the fuze box? If you suddenly have...
try coils 1st make sure they are denso brand,then clean out the entire egr system and intake manifold.when all else fails trg the bar s leak
Aloha All! I recently purchased a second hand 2005 Toyota Prius with 169,000 Miles for just under 5k. The first 2 months have been problem free....
Thanks for all the info! I swapped out all the coils from the 2008 to the 2007 and the 2007 is still knocking away like there's no tomorrow. I'm...
Hello, I've been reading this forum for the past 2 weeks non-stop to see if I could get to the bottom of this problem and finally caved and made...
Hey all. Need opinions. I have a 2010 Prius with just over 98,000 miles. Yesterday ( below 20 degrees outside ) I went to leave to go to town and...
I picked up a (barely) running 2007 today, fully loaded, for $750. The PO said he was driving down the highway, it ran hot, and he had the car...
Great post and glad you restored vehicle fuel efficiency. Did you have to disconnect the 12v battery lead before you began removing egr circuit?
Hey all, today I wanna share my experience fixing the misfire problem on my 2010 prius. So the short version is that cleaning the EGR cooler, and...
Install an oil catch can and all of your problems will go away. Your intake plenum is filled with oil/water/fuel and is sucked in at start up...
Hello fellow Prius owners. Great forum! I have an issue with my 2003 Prius that I can't figure out. Maybe someone on here has experienced this. I...
...and lot's of lights. codes from dr. prius showed P0300 P0301 P0303 P0351 - but only when I pulled connector from cylinder 1 coil - and then...
What I have learned is that you can simply measure the voltage to identify if there is any voltage leak in the pack. Myself, I was gonna open up...
I also ordered a megohmmeter and I will see what can I do from there.
You have several issues. The no start(won't go into ready mode) after the triangle comes on is the P0AA6 with subcodes 526 and 612 indicates a...
Office of Defects Investigation Technical Service Bulletins - Search Results Report Date : April 26, 2007 at 12:54 PM Service Bulletin Num :...
