Separate names with a comma.
Can the orange seal be pushed in tighter to the connector so it edge seals/laterally, but doesn’t impede vertically/axially seating the connector?
From appearances, the orange seal should be down-hole, serving as an edge seal on the mating connector.
That’s a hella pipe extension weld…
The center knob is multi-function. Thermostat, fan speed, air duct routing selection.
Does air flow increase when you manually turn the round fan control knob to high? It does sound like there is a flow constriction.
Does cold airflow increase when you turn the round automatic temperature controller to its minimum low?
What are the yellow things? Brake caliper covers?
At the time, circa 2018, that was my concern. Whatever heat cycle damage may have been done would not be rectified by a firmware reflash. And...
Why would you choose not to get it done?
You're sure you fully re-plugged and re-snapped the orange HV harness connector?
There's always the 'IGNORE' option...
I have used both Lasfit and Oxilam LEDs to replace what were OEM incandescent/halogen bulbs on both high and low beams, in both reflector and...
National sample of one -- a steady, calculated, 42.8mpg, below and past 50k miles, OEM and replacement tires...
Approaching a full-spectrum wire...
Either the timing chain jumped, or the sensor is mis-positioned, or both.
We also use a CTEK 4.3 on the ‘fleet’, each with charger state telltales. No issues, whether wet or dry cells.
Full wallet flush…
I use a12.7V relay to trigger the fogs for use as DRLs. Works fine. Has about a 30 second dwell after ignition cutoff.
It could also be the condition of the locking mechanism. I've had to go the mechanical key unlocking route twice, and in neither instance did I...
Cost-effective problem solving is a valuable skill.
