Separate names with a comma.
It is not difficult to get the Cygwin X window/shell running and then you should be able to run the executable of course is much easier to run the...
What is the DOS Shell saying? Post a screen capture if you can. Installation of the VCP for the FTD Chip or whatever USB-UART Chip that is being...
ScanGauge is good If you are more into it have a look at PriiDash (TM) - PriusChat Forums or...
The water portion of the sulpuric acid electrolyte that is used could have been removed by electrolysis (maybe at some impurity points on the...
The dark brown colour of the plates is a good sign as the Lead Dioxide aka Plumbic Oxide from my high scool chemistry classes, is what is needed...
Re: 115200 baud for bluetooth test Ok I downloaded the file and it works with the laptop driving a Roving Networks RN-42 Bluetooth-UART connected...
None. Million $ answer? I read on PC that the Prius ECU should go directly to S4 when the ICE is started above a certain temp esp for Gen 3....
Broken or blocked fuel pump or fuel pump driver circuit open caused by moisture in the pump connector cabling ( connector seals defective)
Micro Pulse and Glide or Integral Pulse and Glide.
The 'fuel usage display' is the MPG measured from the prior Reset to now so was the the Reset on the MFD fuel usage display used to clear the...
I got it working a couple of days ago. Encountered the issues in the FAQ . I used a ScanTool OBDLink XL and a Netbook wth W7 Pic attached, shot...
Ok Here is what I had to buy; 1. Hardware a. Arduino Uno b. SparkFun CAN Shield c. Connectors to be able to plug in Shield into UNO d. OBDII to...
Alex, Compiled it and downloaded into the Arduino Uno/Can Shield. Took the liberty to change a couple of the message strings. Ran a quick check in...
I sent you a PM just now.
When the Gen2 goes OFF, it switches OFF the +5V supplied on the pin the ECT_Spoofer uses for power.
The Link indicates where the sensor and ground are located, do you know where +5V is located on the Gen3 ECU?
For use on a Gen3, the difference is the pins on the ECU are different. I do not know where the +5V pin is located. ken1784's post does not...
I measured the current consumed @ 5V: 1. Stanley LED 4x 12.5mA on start for 3 secs, 8.26mA thereafter 2.. Rohm Pico LED 4x 6.82mA on start for...
Ray, The board has been re-spun to move the MTA connector to the TOP edge so that the latch for the SD case does not need to be removed. I...
Should be low enough as the estimated power dissipation on the card is 50 milliwatts. A fast acting low current SMD fuse is in the +5V feed on...
