Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
I should have clarified in the original post that we would like to check it for the purpose of putting it into a different Prius which has a...
We drove it with that battery until July 2022 when it started to have engine problems (not maintaining compression) possibly related to a deer...
The engine on our previous Prius died at the end of last summer. We had replaced the entire pack with cells from a donor car about 3 years prior...
Pics of above mentioned piece
A couple of weeks ago, my husband was driving when the car started shaking and he noticed a burn kind of smell. We got it to a mechanic and were...
The new-to-us pack has been in for 5 months now and we've driven another 3000 miles or so and I'm happy to report that all is well.
The initial straight up lift to get it out and over far enough to the trunk edge for two people to carry it was difficult (his back was sore for a...
I plan on it. I couldn't have done this without the help I got here and I'm just so pleased it worked. I hope the thread itself helps someone...
We reconnected the battery, turned on the car and all the error messages were gone. Wahoo! We reconnected the cooling system and bolted the...
The battery is back together and we're ready to put it back in and cross our fingers. Any tips for getting the battery back in without my husband...
Just one and it is under the case. I didn't know if the screws helped to ground each cell or something. Thanks.
So this may be a stupid question, but when I neared the end of putting all the under screws through the bottom of the case and into the modules...
I meant to write down which modules had the clips on them for the temperature sensors, but I didn't and now I'm not sure. I'm thinking 1, 10, 15,...
They all look really good. Raytheeagle had mentioned the ones that used to be on the end might not be as flat. I haven't noticed anything...
That explains why only two of the posts had nuts on them. My husband took the top off the case and I thought maybe he had already removed them....
I wanted to clarify for anyone reading this thread for help. As far as I can tell, the posts that sit at the four bottom corners of the battery...
After reading through his post, I can visualize it. The rods hold all the modules together and then I can screw it up tight and then do the...
So is sounds like I need to take out the two silver screws holding the whole battery rack in place. I'll try that.
I don't think we have a compression rack, but that sound useful. I wondered if a couple ratcheting tie down strips might help.
The modules arrived today and the serial numbers check out (fourth digit is O indicating 2013). The cells have about 7.68 volts. I got the old...
