Separate names with a comma.
If puston boots are in good shape, can the pistons just be pushed back in or should the boots be removed and then the pistons cleaned first?
Interesting. Im wondering whether the rings lose tension over time. Low tension rings would definitely be more vulnerable to gum/buildup. The...
I would assume that if possible, it is best to have some pressure on the caliper as the bleed screw is cracked open. I like the idea of clear...
I recently did a piston soak using the following technique. I think the result is good but of course, I didn't tear the engine down to examine the...
On my 2013, I am doing front pads and rotors. I disconnected the 12v before starting. Now, I'm ready to compress the caliber pistons but wondering...
I don't have a factory service manual but I guarantee I can reseal a gen 3 timing cover gasket without pulling the engine. My guess is pull the...
I did order the rebuilt from Texas Hybrids so that should be here in a day or two.
Car starts but CM display may or may not be blanked out and Power Button is not illuminated when I'm thinking it should have a green light (On in...
I will definitely check into the rebuilt unit mentioned.
My 2008 recently lost its instrument display but I looked on YouTube and did the fix suggested. Instruments came back but I really haven't driven...
My deepest apologies to anyone who was inconvenienced or traumatized by any thread duplication. I don't recall bringing this issue up before....
My 2013 has excessive crankcase pressure. It runs fine with and has no trouble codes. As Taylor Swift might say, "the ICE has been through it" and...
I drove 200 miles today (in a single drive) and it's up from 39 to 47 mpg. Check engine light is off but the scanner still shows the P0401 code....
Today I did put some smoke into the air intake circuit. The O-ring on the MAF sensor was enlarged/stretched creating a leak there. It's much...
Makes sense. I drive Uber and sometimes show that screen to passengers. Many times, my gen 3 ICE is so quiet at low rpms, it can't be noticed so I...
I'm wondering whether the car I've called PriTanic might be haunted. Today, I was watching the Power Management Display in low speed driving....
P0401 continues either as permanent or as 3 codes...all P0401...either permanent, stored, or pending. Also, rough running at idle or some low...
Thanks. Yesterday, I noticed the EV dash lettering came up on deceleration briefly a couple times. I was in ECO mode at the time as usual. The...
Thanks. I did clear codes but I guess that permanent code is still stored until completing the drive test cycles. Is the slight shuddering...
Thanks for the info. So I'm guessing either a Mode 6 compatible scanner or tech stream at the things that would work here, other than just...
