Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Any update on this? Is the problem fixed?
Just to make sure catch can is clean of the crude. I agree that not washing is fine too. I am just a bit OCD.
Here is a shorts on my OCC cleaning routine. I just do it whenever I feel like it. Haha..cause it's so easy and quick....
Just changed my oil on my Gen 3. Tried the fumoto drain valve on it. It does add a bit to the clearance. So I didn't installed it. I will use it...
Have you tried pouring new oil into the engine to displace the old oil stuck at the bottom of the oil pan? This would somewhat drain a bit more of...
You are using this on your gen 3? How's the clearance?
Anyone using Fumoto oil drain valve? I am thinking of putting it on my Prius Gen 3 on the next oil change. [ATTACH] Read that there might be...
"Problem is some oil is supposed to enter the intake, it's the reason the oil/air seperator (the car already has a "catch can" built into the...
Recently there is a post in reddit at Prius sub where someone posted a question on OCC. Someone replied that OCC are not needed as it does not...
Yes, the PCV does reside at the left top of the engine. It does means there is no need for a oil catch can then. I will probably use the spare OCC...
The intake manifold does not look that bad either. Again, maybe the previous owner had it cleaned before. Even the EGR cooler looks to be in...
The throttle wasn't that dirty. I am not sure if cause the previous owner cleaned it or it was like that. The car had 140k km (87k miles)
I can't really find information on oil catch can installation on a Prius C. Is there a need for it? I just got the car used and it does not seems...
Ok, so I have code P0A80 on my Prius C. So I dismantled the battery and checked the modules one by one. I tested each module by hooking it up to...
I was checking on my suspension and found my rack end to be very loose. However, turning and all are still working fine. Didn't feel anything...
I have done changing all my front lights to LEDs. Headlight H11, highbeam 9005, foglight h11 and front side marker t10. Rear all are leds too....
Anyone know or have guide on removing the interior cabin light assembly? Not the plastic transparent panel but the inner one that is attached...
Thanks @Mendel Leisk for the picture of Prius C underbelly. Yes, that circled location is exactly what's shown in the user manual. However, it is...
After looking at the picture and scouring the internet, I am very sure the front jack point is located at the subframe where a huge 19mm bolt (or...
Thanks guys. Though the map might still be damaged, at least I can sleep better knowing I didn't dislodge the doodad from the sensor. It will be...