Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Thanks, yeah the pins were badly corroded. That's great if it's a straight swap of the pc and harness. There's a couple of second hand gen1...
My gen 1 was reading 0 volts on three cells. I have the battery out and all cells are fine . It turns out that three pins are corroded and snapped...
Thanks for the advice, I have the battery out and there was a fair amount of corrosion on the bus bars and sense wires so I cleaned all those, but...
Cool thanks for the info, just found one of them on the starboard side below/behind the headlight , took the connector apart and the wires seem...
Hi peeps, I haven't used my car in about 6 weeks and started it to find P3030. The battery voltage on block 16 is 0v and the adjacent one is...
So..... My gen1 Prius is driving fine and the traction battery is in good health. Although I've been toying with the idea of topping up the...
320v charger 1amp
There is a Fusible link in the back beside the battery and another 100A under the bonnet in the fuse box.
I thought I'd better post on here and update. I changed the inverter for a salvaged one from a junk yard, cost 80 quid. Followed some great...
I have only now had a chance to tackle this car again, with techstream working now it reports sub code 266 along with P3125 . I've bought a brand...
Not afraid to get stuck in..... I like it. Well done Sir.
I realize not many people are driving these old wagons anymore and I get the feeling folk on the group are weary of helping amateurs muck through...
Thanks for the explanation and for helping with the pondering.... You've chimmed in a few times with advice on my gen 1 issue and I appreciate it,...
So if the inverter in not powered when car is switched to "ON" it must the pump that is on. If the MG starts the petrol engine with power from HV...
There is an audible buzz/hum inside the car when the car is switched to "ON" (not ready) It seems to be coming from either the front of the...
Right yeah I got you . There is going to be a certain draw with computers, relays ect..... But I'm losing to much.... It has to be a short...
Well something on the AM2 fuse circuit is sucking juice. The manual says this fuse is "multiport fuel infection system and hybrid vehicle...
The gen 1 doesn't have a start button. It has ACC , ON and then you turn the key a bit more to start "START" to get into ready mode. My current...
