Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
This data sheet may help you its for a HC12 family. going to be doing the same with my MakeController
thanks i was having problems getting to gi & Attila Vass's Homepage... the last week or so the site looks to have been down or my dns servers...
wiki says this about it. ISO 9141-2. This protocol has a data rate of 10.4 kbaud, and is similar to RS-232. ISO 9141-2 is primarily used in...
All the controllers are on the CAN buss the power steering is on the CAN buss but the sensor that tell the CAN controller for the power steering...
Houston we hit a snag, I was right about the location of the steering angle sensor, rember the photo of the thing I thought was the PS TQR sensor...
Re: power steering hacking eliminating the smear!!! So after hours working with the timing for the new chip and some fancy new hardware, I HAVE A...
So wow, a few months its been now, i started a new job, so i have not had any time to work on this much, but i looks like i got a current...
Got the DAC to work, and will be finishing up the controller board for it. As far as CAN, I think it is a grate idea but, I do not have the...
ken1784 thanks for the info. I might know now what that "outer" sensor was. It might be the "steering angle sensor" I do not know any thing about...
UPS: Scheduled Delivery: 03/24/2008 The part was on back order...:( O took the car into the dealer yesterday for the 25000 maintenance, they...
There is no computer control yet. I am waiting for the D to A converter to show up. At which time I should have complete computer control. By...
Ok, looking all over portland for some place that sells D/A converters but looking like I am stuck ordering off the net. looking like some time...
A grate bit of work has been put in senesce the last post. I have a "demo" for you all, its not much but is showing the last test of this after...
Good news the sensor work as expexted. with an out put of ~2.55v when there is no load, ~ 2.06 when turning left, and ~2.93 when turning right.
Haha, another Portlander! The inspiration for the build, was the drive form Eugene to Seattle.
I was waiting for this post, let me make this clear right now. my plan is to get my car to drive a farley strait line with out my help. thats it.....
yah!, well the center is 2.3 to 2.7 V [IMG]
The plan is to use relays that are normal set to factory operation wiring. so in a case of failure the power is removed form the relays allow for...
Yah!!, looking over TIS I have found the torque sensor it is the 4 wires in the green plastic. thay are as fallows TRQ1 - Torque sensor 1 TRQV -...
Thank you the best $10 I Have spent.
