Separate names with a comma.
Thanks for the schematic... very helpful. It looks like I'll have to replace the entire hydraulic line from the back flexi-hose mount near the...
Thanks for the link... similar to the 'exploded' diags. I used to access through [catalogs.ssg.asia/toyota/etc....] Doesn't have a full hydraulic...
I couldn't find a complete hydraulic brake system schematic in my shop manual (just the individual brakes), so when I went to the Toyota parts...
Thanks for GBTM. After making a list of all the variations I had tried, I noticed I had never pressed the brake pedal to place the car in Neutral...
Failure! I finally got around to trying to trouble-shoot an annoying noise in/on a front wheels of my Gen 2 and executed the prescribed procedure...
E-brake cables are fine, I live in a mountainous area, so I set/release the emergency brake regularly, (although I MUCH prefer hand brakes... WAY...
My sincere apologies to everyone, I did not intend to start such a sh*it storm. As the header in my post stated, it was the "Stupid Question of...
That makes sense, but: a) In over four years, it's never happened before; and b) If it's rust, which steel part is sticking to what part of the...
Great, that sounds MUCH safer! I've owned the Gen 2 for over four years, and somehow, the 'double-'ON'-no-foot-on-brake' function escaped me....
Aftermarket from RA
After a few days of wet weather & very high humidity I got in my Gen 2, and one of the back brakes 'held' for a second before breaking-free as I...
The exact same think happened to me when I bought a new set of drums, shoes & hardware... except in my case, the bag said "Right Side" and was...
I need to rotate a front tire (up on a stand) to trouble shoot an annoying noise on my Gen 2. From what I’ve read here, the only way I can do this...
I did all that 'registration' stuff & exchanged the 'credits' that came with the purchase for every additional function available. Since then I've...
OK, so I'll assume the resistance reading across Pins 1 & 4 is alright (although I don't know what the reading on a 'failed' heater should be)....
OK, I'll look for a Denso or NTK O2 sensor... may have to go to the dealer. Thanks for the advice! BTW: I get 800 mv on my scan tool (warm,...
Well, I bought an Autel AP2500E; installed the correct Autel App; initialized the unit w/ VIN, etc. for my 2008 Gen 2 Prius; downloaded the extra...
Thanks for the pin info. Scanner says I'm getting 0.8V (hot) from the sensor, and voltmeter reads 9.0 ohms (cold) across Pins 1&2 (heater) which...
Aftermarket. When the original Bank 1 Sensor 2 went south (approx. 35,000 kms ago) I bought a pair thinking I'd replace both O2s in the bank. But...
2008 Prius (172,000 kms) periodically triggered PO420, no exhaust leaks, good mileage, does consume some (synthetic) oil. PO420 became more...
