Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
So far just seemed like there was some fuel in the you take manifold. Not sure was mixed with some oil.
Hello All We have a 2010 Prius with about 203,000 miles that just displayed the following symptoms: - P0171 - LTFT sits around 23% all the time -...
I have decided to accept it’s a fuel pump. Does anyone know what adhesive to use when putting the service hole cover back?
Hello All One of our 2010 Prius' has a P0171 and a Long Term Fuel Trim sitting around +25%. I compared other sensor values with another 2010 Prius...
Yeah cleaned pins before using and always replace shims.
Amazon: https://a.co/d/hUNs5lo Compatible and colorful
I understand, I usually stick to OEM stuff but I read that silicone is better for higher temperatures and went with that. Does it make a difference?
I did read through and saw that 3M was also good but apparently it isn’t available here so I went with Permatex. Is there a difference?
Yeah, I only knew it was leaking cause I saw the silicone paste oozing out . If it’s that quick and easy I’ll plan to do it soon before all the...
Hello, was replacing front rotors and brake pads on a 2010 Prius and noticed that some of the caliper sliding pin bushing/boot has a crack causing...
Where would I do that don't see any option. Mis-typed the title code is C1391
Thanks, already watched those. Planning to replace parts myself and have a shop in the Bay Area bleed and calibrate. They confirmed they have...
Hello All, our 2013 Prius Plug-in had its ABS, Brake and Traction Control Lights on the dash. I used an OBD2 scanner and found code C1391. Some...
Update: O-ring on fuel injector was twisted going to replace them all and see what happens. Forgot to mention that when the engine turned on there...
Update: Turns out I forgot to plug a connector (I think to the transmission position sensor) back. Car finally turned on with a lot of shaking and...
Hello Just replaced the engine on a 2013 Prius. Upon trying to start the car “P Lock Malfunction” message is displayed. I have searched a couple...
Hello Does anyone know what the MAF flow rate should be with the car on, engine off, not moving?