Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
https://www.northtowntoyota.com/used-inventory/index.htm?make=Toyota&model=Prius I am/was a generation 3 owner. Had pretty good luck with my...
2011 Toyota Prius - VIN: JTDKN3DU1B1355281 This dealer has been sitting on this Prius since last summer. I wouldn't pay sticker price but may...
Previous thread discussion: P0032 - 2011 Prius | PriusChat Basically I was getting two O2 sensor codes P0032/P0038 - fuel running rich, detected...
I remember reading once that 2010 and 2011 Prius Gen 3 were worst for a head gasket. (I personally blew my head gasket on 2011 at 215k miles). I...
Recently, my (2011) rear driver (left) brake pad burned through the ceramic on the pad in a few days. I replaced the wheel bearing (overdue),...
**2011 Prius - 215k miels P0032 - Oxygen (A/F) Sensor Heater Control Circuit High (Bank 1 Sensor 1) Read more at: P0032 Oxygen (A/F) Sensor...
I did not notate the correct orientation of the washers when taking out the Headbolts. Although I don't think it should matter too much, I would...
Hello all, - I am looking for advice on how to set the timing chain. - I am also looking for advice on how to release the timing chain tensioner...
Where are the intake valves located in the generation 3 Prius? If these are carbon fouled/stuck/need cleaning, could that cause engine shaking?...
I am an Uber driver and a few weeks ago I received the heavy engine shaking and code P0303. I drove about 500 miles since shaking began and have...
Hello, hoping I don't have a blown head gasket Hello, I started receiving the shaking during startup about two weeks ago. It would go away at...
