Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
I went ahead and installed BOTH the clearance lights and the fog lights today. I removed the bumper cover to make the job easier. Here are some...
I've got a 2019 Toyota Prius Limited and I just ordered the following parts: LED Side Lights: 812B047020, 812A047020 Housing Inserts:...
Your best bet is to use a shop vac with a tapered cone attachment to suck the clog out. Putting something up the tube may result in it becoming re...
If you are capable and willing, I'd just drain all the coolant and refill with the proper stuff. After you do it once or twice and understand what...
How do you reset ABS light & yellow ((!)) ? | PriusChat
I'd reset the ABS lights using the paper clip method and see if it goes back on. There is a link to this on Prius Chat.
I didn't pay much attention to the calipers, the slide pins did pull out, but you needed to use some force. When I reassembled everything, I was...
Here's an update on my front brake change: I originally replaced the front pads and rotors on my 2006 Prius on 4/17/14 at 132K miles. Fast...
Buy a replacement valve cover on eBay for approx $50.
Maybe this means they will ditch their current battery technology and use Tesla batteries instead? After all, Toyota did invest in Tesla.....
That is the NO. 1 WATER BY-PASS PIPE. Perhaps the gasket is bad? I've attached the pdf for your review.
I don't see the pic, just a broken link.
I'm getting ready to change out the front struts on my 2006 Prius. Is this the coil spring compressor that I need? [MEDIA]
If you try and charge the battery, there is a special Optima Battery Charger for AGM batteries, but it's not cheap ($200). I just swapped out the...
I just replaced both front wheel bearings on my 2006 Prius. I decided to buy new knuckles, lower ball joints, bearings, brake dust covers, bearing...
I only take my car to the dealership for service. You pay more but they have knowledge of the car that other repair shops don't. With that being...
Once you get enough air bled out of the system to prevent it from overheating, still check the overflow daily first thing in the morning. It will...
That's the bleeder for the inverter. If the valve that was replaced is linked to that system, it must be bleed too. that one you place a tube over...
There is a Bleeder bolt on top of the radiator. You connect a hose to the port beneath the bleeder bolt and route it to the reservoir. Be care...
It looks like the CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY