Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Ugg... Got 2011 reassembled. I can NOT get these codes to clear. Using Techstream. Anomaly I see is that the dash LED's don't blink at all...
Thus begins the next phase of getting our 2011 Gen 3 into significantly better shape.*** I've made good progress and will write about that in a...
The OEM part for the Gen3 Prius rear axle support bushing is 48725-47030 I find no alternative for that named part... but quite a few for that...
This is my adventure in DIY rear shims for my Gen 3 Prius. First time I've gone in deeper than wheels on the rear end. I'll fill in blanks later....
In another thread, @The Critic used NAPA-numbered versions of (Spicer? NO -- MOOG!) alignment shims, heavier duty than the typical SPC shims for...
UPDATE: These are by MOOG not Spicer!] In another thread, @The Critic used NAPA-numbered versions of SpicerParts alignment shims, heavier duty...
After 13 years on the road, no surprise: my 2011 Gen 3 TPMS sensors have been going out. Here are lessons I've learned: Sensor Sourcing * YES,...
Whew. At long last I believe I've found a way to measure Prius HV battery module DC Internal Resistance that gets results similar to what we see...
I hadn't noticed this documented, so here are the details for replacement bolts and nuts on battery modules. 1) All threads are M5 x 0.8 2) For...
I've been working on my 2011 Prius, that has a new 2015 engine. Was doing body work etc... in retrospect I'm not too surprised the 12v battery...
I have an almost-new front apron (front most black plastic underneath.) Already, it is showing signs of stress and wear. The plastic corners...
I just discovered I have an issue with some missing bits at the rear end of my 2011 Gen 3 passenger body side moulding. I'm sure I can repair the...
Gen 3 Prius, across the top of the front bumper cover where the hood drops down... there's a long cushioning strip. In replacing my bumper cover,...
Auugh. I have the "PriusChat" Euromud guards on my 2011. Except, the right-rear mud guard fell off sometime during a recent trip Does anyone...
A 2023 report on 3m film, applied to a 2011 Prius right after purchase (late 2010)... and replacement clear bra on the front bumper cover about 7...
I spent a few round-toit's digging into the details on the J2534 bus, its specs, and the free Bus Analysis Tool. Here's what I learned. (NOTE:...
I need to temporarily remove the plastic holder for the gas cap release lever (on the floor next to driver)... due to vomit getting under there :(...
Had a wonderful trip to Buena Park, CA to visit Hybrid Pit Stop... who swapped out our 218k mile 2011 engine for their "gold" comprehensive...
Context ASAP, but for now... I likely need to remove/replace my oil pan. What size are the pan bolts? I found cheap plastic "pop ups" that make...
I am taking care of refitting the lower front splash shield (p/n 52618) on my 2011. Every diagram shows two outer front screws that go into a...