1. Attachments are working again! Check out this thread for more details and to report any other bugs.

rear bumper guard

Discussion in 'Gen 2 Prius Main Forum' started by kente777, Jan 22, 2006.

  1. kente777

    kente777 New Member

    Joined:
    Oct 20, 2005
    194
    0
    0
    Location:
    NW Florida
    Does anyone know what type of adhesive is used to secure the rear bumper guard? I just had mine installed by the dealer and as I was washing my car today, I noticed that there is a gap on each end where water can get trapped underneath (which of course could encourage rust).

    Any ideas?

    thanks.

    Ken
     
    #1 kente777, Jan 22, 2006
  2. koa

    koa Active Member

    Joined:
    Aug 9, 2005
    980
    45
    0
    Location:
    Hawaii
    Vehicle:
    2006 Prius
    It's two strips of two sided tape. The bumper is plastic and won't rust. Unless the whole piece was embedded in caulk, it's better to have a gap for the water to evaporate/drain.
     
    #2 koa, Jan 22, 2006
  3. seasalsa

    seasalsa Active Member

    Joined:
    Feb 29, 2004
    1,278
    20
    0
    Location:
    Kent, WA
    Vehicle:
    2010 Prius
    Model:
    II
    Did you get the clear applique or the black heavy plastic protector?

    If it is the clear one, take it back to the dealer and make them do it right.

    If it is the black one it should not cause any problem, no chance of rust on plastic.
     
    #3 seasalsa, Jan 22, 2006
(You must log in or sign up to post here.)