So I got two new parts for my Prius today.

I'm sorry, but I am laughing so hard it hurts................I think this one was packaged by a guy named "Ray Ray"

 

We got any big boxes? Awww, never mind.

 

Are my ears ringing from someone using my name or @edthefox5 ’s name in vain.

 

Yeah I bought a fender liner off eBay once too and it was a piece of junk just like that.
Looked nice in the picture though lol. I threw it out. The oem online wasn’t too bad.
The cheap online bumpers are awful too there so thin they look like crap installed there super wavy and thin, probably flop around driving down the road. They look ok sitting there off the car but after install it’s bad.
Especially if on a dark car.
I bought a used oem bumper from Todd in Tampa so waiting till I get hit in the back again lol.

But haven’t been hit since I put a motorcycle blinker on my third tail light. Nice very noticeable blink 4 times
Every time you hit the brakes,

 

LoL, no, not you Raytheeagle, you offer so much great advice! How about a guy named "Hambone" or "Buzzy" or "Nitro" or "Stinky" or "Spanky" or even "Doofus"

 

The fender liner might be just fine; unroll it and install, see how it goes. A bit of massage with a heat gun might help too. It is just a flexible shield, inside the front wheel well.

 

I agree. I'd give it a try. Since it's small enough, maybe put it in an oven at a low temp, or in a sink/bucket of hot water, then remove it and work it out by hand while it's pliable. What do you have to lose?

 

I've had that liner almost completely out, it's very bendy. There's an internal steel bar splice with 3 bolts, that turn into lumps of rust after a few years. There's also one plastic fastener at the back that pretty much have to be destroyed to remove.