So the wires just push the wafers against the lens and when the lens was put back in, it secures it in that manner ? Other than that they are just plug ins ?
Because the bulbs have the metal tips that hold the lights in place, so I wasn't sure how the wafers get held in place..
Do you think you could possibly post some pictures of what the wafers look like inside the light housing ? Thanks again !
I use adhesives to keep them together but not stuck to any of light assembly. All lights are pressure fitted between the lens and the light assembly. The only one not pressure fitted are the front map lights. They just sit on the lens. The wires keep them from moving. None of the lights are loose. They are very tight fitted.
Hey I like the LED set up that you have inside your car. So if I understand correctly, you are using wafers with multiple LED lights in a strip and they get adhesive to the corresponding light sockets ? That was what I wasn't sure by looking at your pictures is how you were able to secure the LED wafers/strips.
Also do most of the light covers unclip with a screwdriver ? There are some bulbs that I'd like to replace with more light, noteably in the trunk and dome. Thanks !
