1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Clazzio Covers/REAR SEAT REMOVAL - HELP!:)

Discussion in 'Gen 3 Prius Accessories and Modifications' started by unit333, Jan 23, 2010.

  1. unit333

    unit333 Junior Member

    Joined:
    Dec 20, 2009
    77
    7
    0
    Location:
    NYC
    Vehicle:
    2010 Prius
    Model:
    II
    Hey
    I got the Clazzio dark gray for my Prius 2010
    The front ones were fairly easy to install and look very nice. However I read from cover to cover each thread regarding how to remove the rear seat and how there are 2 pressure hooks underneath that you press, etc and yet I cannot even find them. I looked for 30 minutes, touched every inch multiple times and no luck. Can you guys give me a real simple explanation of the process, maybe even post a picture or two if you have it, so I can actually really visualize what we are talking about.

    Thank you!
     
  2. radioprius1

    radioprius1 Climate Conspirisist

    Joined:
    Aug 13, 2009
    1,355
    155
    0
    Location:
    Iceland
    Vehicle:
    2010 Prius
    Model:
    II
    You literally just put your hands under the seat and pull upwards. It will come right out.
     
  3. unit333

    unit333 Junior Member

    Joined:
    Dec 20, 2009
    77
    7
    0
    Location:
    NYC
    Vehicle:
    2010 Prius
    Model:
    II
    I tried, still not working
     
  4. Boo

    Boo Boola Boola Member

    Joined:
    Feb 13, 2007
    5,051
    481
    97
    Location:
    Flushing, NY
    Vehicle:
    2007 Prius
    Model:
    N/A
    If the rear seat is like the Gen II, there are two hooks/clips in the front -- one in the middle of the passenger side seat and another in the middle of the driver side seat. You can unhook both hooks by lifting the seat up with your left arm on the left and your right arm on the right (alternatively, the Seat Assembly Instructions say to unhook each hook one at a time).

    Once you lift the front up you should be able to see and unhook another hook/clip in the center rear.

    Here are the Gen II Seat Assembly Instructions. Page 15 illustrates and describes how to remove the rear seat cushion:

    [​IMG] SE%20-%20Seat.pdf
     
    1 person likes this.
  5. rrolff

    rrolff Prius Surgeon

    Joined:
    Aug 19, 2009
    1,610
    246
    0
    Location:
    So Cal
    Vehicle:
    2010 Prius
    Model:
    III
    This is correct - you grab, and yank it up *hard*. It will unlatch. You may end up having to get a new plastic latch piece (it's probably 50/50 chance). They're like $4.
     
  6. Harry and Nancy

    Harry and Nancy New Member

    Joined:
    Mar 9, 2011
    15
    0
    1
    Location:
    Big Bear, California
    Vehicle:
    2011 Prius
    Model:
    II
    Thank you all for help. This Forum is dynamite, no, it's a gold mine! Should've been here before we bought! Hindsight is 20/20.
     
  7. BNAL

    BNAL New Member

    Joined:
    Jul 14, 2010
    8
    1
    0
    Location:
    Temecula, CA
    Vehicle:
    2010 Prius
    Model:
    III
    The only difference with the gen II and III is that there are 2 rear hooks. It does take effort to get the hooks free, but as long as you pull up there should be no damage to the clips.

    One thing a lot of people are having problems with is getting the front hooks to fasten when putting the seats back. I had the same issue, but today tried again, but this time I tilted the seat backs down about 45% and pulled up on the rear hook and down on the front. The front hook locked in place with little effort. I repeated the process on the other hook and the seat is locked in place.

    I hope this helps.
     
    1 person likes this.
  8. us_matrix

    us_matrix Member

    Joined:
    Dec 28, 2010
    110
    10
    0
    Location:
    California
    Vehicle:
    2010 Prius
    Model:
    II
    Does anyone know that if the Gen II rear seat hooks/clips postion same as Gen III. In the Gen II PDF doc from page 15. It shows two clips in front and one hook in the center rear? Same postion as Gen III?
    I am going to install Clazzio cover and want to find out where are the clips/hook located.

    Thanks.

     
  9. Steve23

    Steve23 New Member

    Joined:
    Apr 8, 2011
    5
    1
    0
    Location:
    USA
    Vehicle:
    2011 Prius
    Model:
    III
    Guys,

    With the thread here I was able to easily remove the rear seat bottom but I had the same issue getting it snapped back in. I saw that the two front metal bar loops were supposed to snap back into the plastic receptacles and I used a plastic trim removal tool to pop the receptacles out of the metal bracket and then I popped them onto the seat loops with a rubber mallet. (This is with the seat bottom out and upside down). Then the seat snapped right back down no problem. (I was putting Wet Okole's on and they look fantastic) (Gen III 2011)

    Steve D


     
  10. bear15

    bear15 Member

    Joined:
    Jan 28, 2006
    168
    35
    0
    Location:
    Suburban Chicago
    Vehicle:
    2015 Prius
    Model:
    Three
    2012 Prius REAR SEAT REMOVAL and REINSTALL - HELP!:) 3-2-2012

    Removal-
    Slide hand under the front of the rear seat approx. 1 foot in from the end. Using both hands, YANK up hard until the side comes up. Do the same for the other side. For best results, use 2 people: one on each side of the front edge of the seat bottom.

    Reinstalling-
    One item many people are having problems with is getting the front loop hooks to fasten when reinstalling the rear seat bottom. We had the same issue.
    Try: Tilt the rear seat backs forward approx 45 degrees so you can get your hand down to the rear loop hook. While facing the rear of the car, pull up on the rear loop hook and kneel down (using much pressure) on the front while gently moving from side to side. After a moment or so, you should hear a click indicating that the seat is installed. Then go to the other side and do the same. If this does not work, check to see if the plastic pins in the plastic receptacles are broken and/or try the below.

    Or

    I saw that the two front metal bar loops were supposed to snap back into the plastic receptacles and I used a plastic trim removal tool to pop the receptacles out of the metal bracket and then I popped them onto the seat loops with a rubber mallet. (This is with the seat bottom out and upside down). Then the seat snapped right back down no problem.

    Note: If replacement receptacles are need, they only cost approx. $5.00 each.
     
  11. chami

    chami New Member

    Joined:
    Apr 7, 2012
    1
    0
    0
    Location:
    Mount Lavinia,Sri Lanka
    Vehicle:
    2010 Prius
    Model:
    N/A
    I am going to remove the rear set of mine pretty soon.

    Just want to be confirm a place on ebay or Amazon for a replacement of the 'plastic clips' just in case.

    Having trouble finding one though most have commented its just $4-$5.

    Can someone please tell me how to search ( A part no. ? ) or a link where I can find it.

    Thanks in advance.
     
  12. Dakine50

    Dakine50 Member

    Joined:
    Jul 5, 2009
    148
    22
    0
    Location:
    Nor-Cal
    Vehicle:
    2011 Prius
    Model:
    Two

    There's a few videos on Youtube. Just enter 2010+ Prius rear seat removal. Hope this helps.
     
  13. revhigh

    revhigh MPG Enthusiast

    Joined:
    Jan 2, 2011
    986
    141
    0
    Location:
    PA - Pocono Mountain Area
    Vehicle:
    2010 Prius
    Model:
    II
  14. Dakine50

    Dakine50 Member

    Joined:
    Jul 5, 2009
    148
    22
    0
    Location:
    Nor-Cal
    Vehicle:
    2011 Prius
    Model:
    Two
    Thanks for posting the video Revhigh,

    My computer skills suck big-time.....lol!
     
  15. iskoos

    iskoos Active Member

    Joined:
    Dec 24, 2017
    399
    246
    0
    Location:
    Orlando, FL
    Vehicle:
    2010 Prius
    Model:
    III
    When posting a video or PDF file that is part of a forum thread, the poster needs to make sure those files will be available to others all the time otherwise the thread will be useless. In this thread, both the video and the PDF files are not accessible anymore.
     
    ASRDogman likes this.