1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Question about carbon clogging in egr system

Discussion in 'Gen 3 Prius Main Forum' started by Jim Caldwell, Jan 28, 2022.

  1. Jim Caldwell

    Jim Caldwell Member

    Joined:
    Mar 22, 2015
    142
    25
    0
    Location:
    Mathis
    Vehicle:
    2014 Prius
    Model:
    IV
    I have a 2014 Prius at 165k miles. The gas mileage is not what it should be. I got the car at 140k from a dealer, so probably the egr system has never been cleaned. I hear it will set a code po401 ( I think) when its clogged up. I have techstream, and it hasnt set this code. Will i get a chk engine light for this dtc also?
    I am 70 yrs old. I did recently replace spark plugs and coil paks. Seems like my mpg even decreased a bit after this instead of helping. But cleaning the egr system, i think its just too big a job to try to do this myself. I think it needs to be done at toyota dealership. How much should a mechanic shop cost to clean the egr and intake? ( or the number of hours it should take so I can do the calculation myself) Problem is--- besides expense--- is that I dont trust either of my two dealerships. I have really no confidence that they would actually clean it out. Theres no way to tell if they really did.
     
  2. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    7,797
    1,349
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    It's about an 8 bolt job or so all up on top of engine I believe 1/4 drive ratchet a few wrenches on a 75 degree day no issues I'm you're age too . On tech stream you can read the flow of egr in HG numbers I cannot rem how lowis getting bad 14 comes to mind Chapman I think recently posted the numbers good luck buddy .this exact problem blew my 2013 engine crack in no 2 piston crown . Now new engine
     
  3. ASRDogman

    ASRDogman Senior Member

    Joined:
    May 29, 2018
    5,837
    3,137
    0
    Location:
    Florida
    Vehicle:
    2010 Prius
    Model:
    Two
    They won't clean it, they replace the parts. And it will be expensive.
    If you can change the spark plugs, you are about half way there.
    It's not really hard, just takes time. If you take your time and take one part at a time,
    you can do it.
    Use a pressure washer and oven cleaner on the egr cooler. And "Gunk" on the intake manifold
    and other plastic parts. Don't use the oven cleaner on the egr valve though.

    Maybe someone is near you from Prius Chat that would be willing to help you.

     
    mikey_t and Raytheeagle like this.
  4. Raytheeagle

    Raytheeagle Senior Member

    Joined:
    Jul 1, 2016
    11,251
    15,474
    0
    Location:
    Bay Area, California
    Vehicle:
    2019 Prius Prime
    Model:
    Prime Plus
    If we only knew where or which Mathis :whistle:.
     
  5. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    7,797
    1,349
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    How bad is the gas mileage??? I was still in hi 40's at no 2 cyl fail . Like 46 47 similar to my gen2 .then no 2 code I knew what that stumble was is..
     
  6. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    54,474
    38,105
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    If you can get to the plugs you're halway there. See first link in my signature.

    70's not that old, is it...?
     
    Montgomery likes this.
  7. bettergolf

    bettergolf Active Member

    Joined:
    Jan 8, 2019
    403
    331
    0
    Location:
    Sanford NC
    Vehicle:
    2015 Prius
    Model:
    Two

    Not really ...until you look into the mirror!
     
    Montgomery and Mendel Leisk like this.
  8. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    23,072
    14,976
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    It's kind of a grueling job in a Gen 3 liftback. In a Prius c, the stuff is more exposed on the top of the engine, but in the liftback it's kind of buried off the inboard end of the engine and under the cowl.

    The thread about monitoring the flow test results is this one. You can watch trends over time in the flow results and see what is happening way earlier than the point where a P0401 would be logged. That's very easy and comfortable to do, nothing but plugging in to the diagnostic port in the cabin.

    The flow test results don't really cover the four individual passages in the intake manifold itself. Those are better just directly inspected now and then. But that job is easy.
     
    mikey_t likes this.
  9. StarCaller

    StarCaller Senior Member

    Joined:
    Feb 15, 2014
    1,240
    692
    0
    Location:
    Cedar Crest, NM, USA
    Vehicle:
    2014 Prius
    Model:
    Two
    "Mathis is a city in San Patricio County, Texas, United States. The population was 4,942 at the 2010 census."
     
  10. Jim Caldwell

    Jim Caldwell Member

    Joined:
    Mar 22, 2015
    142
    25
    0
    Location:
    Mathis
    Vehicle:
    2014 Prius
    Model:
    IV
     
  11. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    23,072
    14,976
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    "Mathis is an unincorporated community in Dallas County, in the U.S. state of Missouri."
     
  12. Jim Caldwell

    Jim Caldwell Member

    Joined:
    Mar 22, 2015
    142
    25
    0
    Location:
    Mathis
    Vehicle:
    2014 Prius
    Model:
    IV
    Another question: when the egr system is getting clogged up, what are the symptoms?
     
  13. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    23,072
    14,976
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    From uniform clogging (the kind the self-test can detect), not much in the way of symptoms. The ECM has the flow test results and it controls how far the valve opens, so there might be nothing obvious, until one day it decides the clogging is too much and sets a P0401 code.

    From nonuniform clogging among the four small intake manifold passages, you can get an engine that runs smoothly at low throttle and at full throttle, but gets a bit rough at mid loads where EGR is used. The EGR valve opens at those mid loads and then you have some cylinders getting too much EGR and some too little, resulting in roughness.
     
  14. Jim Caldwell

    Jim Caldwell Member

    Joined:
    Mar 22, 2015
    142
    25
    0
    Location:
    Mathis
    Vehicle:
    2014 Prius
    Model:
    IV
    Okay.....so loss of mpg isnt a symptom of clogged egr passages?
     
  15. rjparker

    rjparker Tu Humilde Sirviente

    Joined:
    Jun 6, 2008
    7,475
    4,373
    7
    Location:
    Texas Hill Country
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    $800-$1000 at a dealer who will install a new egr cooler and valve. You will get no improvement in mpg unless it was totally clogged and giving you the code. An independent mechanic "might" do it for a couple hundred less if he has experience doing it on a Prius of this generation.

    In most cases, reduced mpg is caused by an old high voltage battery. Or short drives of a few miles or less. Or high speed driving of 70 or higher.

    If we knew where you lived you might get mechanic recommendations. If you still have start up rattles and brake booster codes I would not spend much time or money on the egr system. Repairs to the engine could include a refreshed egr if you shopped carefully.
     
    #15 rjparker, Jan 30, 2022
    Last edited: Jan 30, 2022
  16. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    54,474
    38,105
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    165k is a symptom of clogging.

    Someone reported blown head gasket symptoms with a v, today, with around 120k:

    Violent shake and Misfire | PriusChat
     
    m.wynn likes this.
  17. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    23,072
    14,976
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    Who knew?! Keep the EGR unclogged and the car never gets old!
     
  18. rjparker

    rjparker Tu Humilde Sirviente

    Joined:
    Jun 6, 2008
    7,475
    4,373
    7
    Location:
    Texas Hill Country
    Vehicle:
    2012 Prius v wagon
    Model:
    Three
    Mendel has disclosed a previously secret rollback option for used cars. "Entrepreneurs" no longer have to pull instrument panels and send them to one of our helpful Priuschat members. No more unnecessary shipping delays. Now they clean the egr with oxiclean and a carwash and the miles dissolve away.

    Since we have guys from Monterey:

    Now heres a guy to explain the joke.JPG
     
  19. Jim Caldwell

    Jim Caldwell Member

    Joined:
    Mar 22, 2015
    142
    25
    0
    Location:
    Mathis
    Vehicle:
    2014 Prius
    Model:
    IV
    Ok. I think i will do the egr & intake myself, buying a used but cleaned cooler, and a new egr valve. There are quite a few new egr valves up for sale in 175.00 price range on eBay. These parts are p/n 04004-58137 and the vendors say they are for years 2010 thru 2012. Really? Will they perhaps fit in any gen3 car (mine is a 2014 prius) to yr 2015? Or was there a different valve used in first 2 yrs of gen 3 production?
     
    PriusGuy32 likes this.
  20. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    54,474
    38,105
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Finding a fully cleaned cooler for a reasonable price might be a tall order. And cleaning the valve is quite easy. That's a lot of $'s to save a few hours labour. With your miles I'd just clean what you have, and would likely be best to replace the pliant gaskets on the intake manifold. That entails the interfaces with throttle body, cylinder head and egr pipe.

    FWIW when I did ours around 70K kms, I replaced nothing.