Replaced fuse box housing - transmission "P" lock mechanism appears

Update

Removed broken pin and soldered a new pin from junkyard fusebox. Without putting it back in housing, I reconnected all components.

Park - No red triangle or P Lock on screen
Reverse - No red triangle or P Lock
Drive - Red Triangle and P Lock shows up

But car still moves in reverse and drive

Must be one more broken connector somewhere.

Anyone happened to know which pin lol

One thing I noticed. very rich gas fume when engine is running.

 

Interesting but no. I been driving it and it went off after i replaced fusebox housing. So far I fixed the two broken wires. Still same result. but got code pulled this time.

 

After fixing two wires in fusebox .. I ran another scan with techstream. It showed up more devices ..

 

One thing I noticed different

I could get in car and hold brake and press start then it ready to drive before I tried replacing fusebox housing

Now when I hold brake and press start row of yellows dash light comes on but car not in Ready mode .. I waited a minute still not in ready mode

If I press start second time .. Ready light come on and car will drive but still red triangle and P lock only in drive. not in Park or Reverse.

Any idea what could cause this condition?

Going to clear code now and scan again to see what happens.